Why does my car light come on when I go up hill?
Why does my car light come on when I go up hill?
The bit of oil he is burning is getting by under heavy ‘loads’ on the engine. The combustion process changes just enough and triggers the light. The engine is under greater loads going up hill. CUINOZ13, try some very hard acceleration on a flat surface and the light will come on.
Why is your Ford check engine light on?
Why is Your Ford Check Engine Light On? – YouTube Why is Your Ford Check Engine Light On? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Is it possible to find a misfire in a Ford?
It’s possible to find a misfire in your Ford, even if there is no check engine light. All you need is an OBDII scanner with Mode 6 function. It is a common situation. You’re driving your F150, F250, E150 van, or Expedition, etc and you can feel the engine skipping here and there.
What does it mean when your engine hesitates under load?
An engine that hesitates, stumbles or misfires when accelerating or when it is under load, is an engine that is either sucking too much air, not getting enough fuel, or misfiring. If the Check Engine Light comes on, you may find any of the following codes: P0171, P0174 Lean fuel condition codes P0120 to P0124 Throttle position sensor codes
What causes a flashing check engine light on a Ford F150?
While a majority of the time, the flashing check engine light is going to be caused by a misfire related to your F150’s ignition system or fuel system (as stated above), there are other issues that can cause it. Your timing chain could have jumped .
What is the diagnostic code for Ford check engine light?
Refer to our Generic OBD II code list for definitions on all other Ford diagnostic trouble codes. P1000 OBD System Readiness Test Not Complete P1001 KOER Test Cannot Be Completed
Why is my transmission slipping in my Ford F-150?
You may be stuck in gear and have strange shifting from one gear to another. The line pressure control solenoid is shorting out. Hard shifts, Transmission Warning Message. You’ll need to check it while the truck is running and the transmission is warm, usually a 1 – 2 mile drive is enough to warm it. If the fluid is low, top it off.
What to do if your check engine light comes on?
In any case, if you notice that the Check Engine Light comes on, you should contact a local mechanic to scan the error codes and determine why the Check Engine Light is illuminated. Once the problem has been fixed, the mechanic will reset the error codes.
