Why do I have a problem with my p2135?
Why do I have a problem with my p2135?
For one, the problem could stem from a faulty Powertrain Control Module, meaning that there is possibly no voltage issue. You could also be dealing with faulty throttle and position sensors. Another possible explanation is that the wires and connections to each of the sensors have been damaged.
What does the DTC code p2135 stand for?
Diagnostic trouble code (DTC) P2135 stands for “Throttle/Pedal Position Sensor/ Switch A/B Voltage Correlation.”. This code appears when your car’s primary computer, which is often referred to as the powertrain control module (PCM), detects a problem with one of throttle and/or the pedal position sensors/switches.
What does p2135 mean on the ECM?
If the data between one of the sensor pairs (e.g, the two throttle position sensors) does not correlate, code P2135 is set. In most cases, the ECM will also force the vehicle into Reduced Power Mode. Users have reported p2135 for the following makes: Chevrolet, Nissan, Ford, GMC, and Suzuki.
What are the TP sensors on a p2135 Chevy?
P2135 CHEVROLET Meaning The throttle Position (TP) sensors 1 and 2 are potentiometer type sensors each with 3 circuits. – A 5 – volt reference circuit. – A low reference circuit. – A signal circuit The TP sensors are used to determine the throttle plate angle for various engine management systems.
What do you need to know about the p2135 code?
Cost of diagnosing the P2135 code. P2135 is a diagnostic trouble code (DTC) for “Throttle/Pedal Position Sensor/Switch A / B Voltage Correlation”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
P2135 CHEVROLET Meaning The throttle Position (TP) sensors 1 and 2 are potentiometer type sensors each with 3 circuits. – A 5 – volt reference circuit. – A low reference circuit. – A signal circuit The TP sensors are used to determine the throttle plate angle for various engine management systems.
What causes p2135 code throttle / pedal Pos switch?
Potential Causes of P2135 DTC. It’s been my experience that the wiring connector or “pig tail” on the throttle body gives problems in the form of a poor connection.The female terminals on the pigtail corrode or pull out of the connector. Possible bare wire on pigtail shorting to ground.
What causes the 2135 code on a PCM?
What causes the 2135 code? 1 Faulty PCM 2 Faulty throttle position sensor (s) 3 Faulty accelerator position sensor 4 Disruption in the throttle position sensor circuit such as an open, corrosion, short, damaged wiring or broken electrical connections
