Why are the brakes on my Dodge Ram so bad?
Why are the brakes on my Dodge Ram so bad?
The brakes on your Dodge Ram tend to take quite a beating. This is in part due to the fact that trucks usually work a bit more than most other vehicles. They are also usually used a bit harder and rougher than most other vehicles.
How do you replace brake pads on a Dodge Ram?
Most new pads come with new anti-rattle clips. Either way, if you keep or replace them, you will want to apply some grease to them to help the pads slide easily in them. Figure 8. Remove the brake pads. Figure 9. Apply grease to the anti-rattle clips. Now that you have the pads and caliper removed and out of the way, you can remove the brake rotor.
What kind of brakes does a Dodge Ram have?
Your Dodge Ram’s brakes tend to work a little harder than most average vehicles. You want to make sure the brakes are fresh so it can keep working just as hard. This article applies to the Dodge Ram (2002-2008). The brakes on your Dodge Ram tend to take quite a beating.
How do you remove the caliper from a Dodge Ram?
To completely remove the caliper, you will need to loosen the banjo bolt that secures the rubber brake line to the caliper (Figure 7). This will be the only thing keeping it attached to the vehicle at this time. When you loosen this bolt, brake fluid will leak out, so be prepared to catch it with a suitable container.
Why are my brakes not working on my Dodge Ram?
Broke the line lose at the block behind the driver side rear wheel and nothing. Did the same at the front and still nothing. I get a gravity flow for the front at the control module and wheels but nothing for the rear.
What are the problems with a 2002 Dodge Ram 1500?
Lighting issues are common in Dodge Ram trucks and are one of the most frequently-cited 2002 Dodge Ram 1500 electrical problems specifically. Owners find that their headlights, taillights or turn signals suddenly stop working, causing irritation at best and a safety hazard at worst.
Where does the brake line run on a Dodge Ram?
The line runs a crossed the rear axle an ties into the line on the drivers side. No fluid there so I went to the front on the truck where the line runs along the frame before it goes into the abs control module.
Discussion in ‘ Exterior ‘ started by Mr78, Jul 23, 2017 . I have a 2005,2500, with the 5.7. I had a rear caliber blow a few days ago, and just had time to change it today.
