Who makes Uniseals?

Who makes Uniseals?

– TOPP Industries Inc
Uniseals – TOPP Industries Inc.

What is a Uniseal fitting?

What Is a Uniseal Fitting? A uniseal or a uni seal is a rubber seal that is used to run pipes through tank walls, water filters, and storage devices. The fitting is inserted into a slightly larger hole of a wall or tank surface.

What is a plumbing grommet?

Uniseals and grommet/barb fittings are an economical fast installation choice for plumbing connection to another pipe or vessel such as drums and barrels, sumps, filters, aquariums, etc. Simply drill appropriate sized hole*, insert Uniseal and push pipe through Uniseal from large diameter side of Uniseal.

What is a bulkhead fitting?

A bulkhead fitting allows piping connections to be made to a tank. A hole is cut in the tank into which the fitting body is inserted. A locknut threads onto the body to hold it in place. The locknut puts pressure on the gasket(s) that allows it to make a liquid tight seal.

How do they fit grommets?

Grommets are tiny tubes which are inserted into the eardrum. They allow air to pass through the eardrum, which keeps the air pressure on either side equal. The surgeon makes a tiny hole in the eardrum and inserts the grommet into the hole. The grommet usually stays in place for six to 12 months and then falls out.

When to use uniseals in tank fittings?

Uniseals for flat or curved surfaces – work in areas where traditional bulkhead fittings will not such as curved surfaces, i.e. pipe wall or round drum wall. Also can be used when access to inside of tank is not practical for tightening bulkhead nuts. Uniseals are just pressed into a drilled hole.

When to use a uniseal for a bulkhead?

Uniseals are rubber-like and are great to use when a bulkhead will not work, especially when trying to attach a pipe to the curve side of a bucket, drum, brute trashcan, large reservoir, or even another pipe. Just use a properly sizes hole saw to create the hold, and then insert the uniseal with the pipe following behind it.

What’s the best way to install a uniseal pipe?

Just use a properly sizes hole saw to create the hold, and then insert the uniseal with the pipe following behind it. In some cases a little liquid dish soap may be used to help installing the PVC into the uniseal.

When to use uniseals and grommet fittings?

Uniseals and grommet/barb fittings are an economical fast installation choice for plumbing connection to another pipe or vessel such as drums and barrels, sumps, filters, aquariums, etc. Uniseals for flat or curved surfaces – work in areas where traditional bulkhead fittings will not such as curved surfaces, i.e. pipe wall or round drum wall.