Which is the best distributor for Chevy S10?

Your Chevrolet S-10 pick-up works hard on the farm, on the road and in town. Whether you’re moving a friend, herding cattle or driving to work, make sure your truck is always ready to start with an S-10 ignition distributor from AutoZone. Use the form above to tell us what you drive. Use the form above to tell us what you drive.

How do you replace a distributor on a S-10?

1. Rotate the crankshaft balancer clockwise until the alignment marks on the crankshaft balancer are aligned with the tabs on the engine front cover and the number 1 piston is at top dead center of the compression stroke. 2. Align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).

When do I need to replace the distributor?

Distributor Replacement Removal Procedure There are two procedures available to install the distributor: Use Installation Procedure 1 when the crankshaft has NOT been rotated from the original position. Use Installation Procedure 2 when any of the following components are removed: The intake manifold ; The cylinder head ; The camshaft

How do you install a distributor on a car?

As you install the distributor, take care not to accidentally move or nudge the rotor. Mount the new distributor on the engine. Re-fasten the distributor in the same spot as the old distributor, lining up the marked location on the distributor housing with the engine mounting point.

How does a distributor work on a Chevy S10?

AutoZone offers quality Chevy S-10 distributors to keep your truck running. Ignition distributors work by routing electrical current, in the proper firing order, from ignition coil to spark plugs. Older distributors consist of a bottom half, which breaks the current to the coil, and a center cam and lever that create a high voltage pulse.

How do you remove a distributor from a S-10?

1. Turn OFF the ignition. 2. Remove air cleaner assembly. 3. Remove the spark plug wires from the distributor cap. Twist each spark plug boot 1/2 turn. Pull only on the wire boot in order to remove the wire from the distributor cap. 4. Remove the electrical connector from the base of the distributor. 5.

How do you replace the distributor on a Chevy pickup?

In some vehicles, the pickup can be replaced while the distributor is left in place. In others, it may be easier to remove the distributor. This method involves leaving the distributor in place. Step 1: Disconnect the battery: Remove the negative terminal on the battery.

Which is the best distributor for Chevy S10?