Where is the parking light bulb on a Chevy Cobalt?
Where is the parking light bulb on a Chevy Cobalt?
The combination brake / turn signal / parking bulb is contained in the largest black socket on the rear of the tail light assembly. Remove it by rotating the socket 1/4 turn counter clockwise and pull it straight out of the assembly. Pull the old # 3157 bulb straight out of the socket and push in a new one.
Where are the fuses located in a Chevy Cobalt?
Fuse box in engine compartment. fuse box location. The engine compartment fuse block is located on the driver side of the vehicle. Lift off the cover to check the fuses. fuse box diagram. type 1. legend. Device Rating Description ABS Fuse 40A Electronic Brake Control Module (EBCM) ABS2 Fuse 10A Electronic Brake Control Module (EBCM) ABS3 Fuse 20A
What are the sensors on a Chevrolet Cobalt?
Evaporative Emission (EVAP) Canister Purge Solenoid, HO2S Sensors, Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor type 2. Heated Oxygen Sensor (HO2S) Sensor 1, Heated Oxygen Sensor (HO2S) Sensor 2, Evaporative Emission (EVAP) Canister Purge Solenoid, Clutch Pedal Position (CPP) Switch, Mass Air Flow (MAF).Inlet Air Temperature (IAT) Sensor
Where is the reverse light bulb on a Honda Accord?
The reverse (back up) light bulb is the medium sized light grey socket located at the edge of the tail light closest to the center line of the vehicle. Turn the socket 1/4 turn counter clockwise and pull it straight out of the tail light assembly. Pull the old # 921 reverse bulb straight out of the socket and push in a new one.
The combination brake / turn signal / parking bulb is contained in the largest black socket on the rear of the tail light assembly. Remove it by rotating the socket 1/4 turn counter clockwise and pull it straight out of the assembly. Pull the old # 3157 bulb straight out of the socket and push in a new one.
The reverse (back up) light bulb is the medium sized light grey socket located at the edge of the tail light closest to the center line of the vehicle. Turn the socket 1/4 turn counter clockwise and pull it straight out of the tail light assembly. Pull the old # 921 reverse bulb straight out of the socket and push in a new one.
How do you replace a tail light bulb?
Remove it by rotating the socket 1/4 turn counter clockwise and pull it straight out of the assembly. Pull the old # 3157 bulb straight out of the socket and push in a new one. Insert the new bulb back into the tail light assembly and rotate the socket 1/4 turn clockwise to secure it in place.
