Where is the heater on a Ford Ranger?
Where is the heater on a Ford Ranger?
There are two motor attachment schemes used on Ford. The older models used screws mounting the motor directly to the plenum box. Access the motor by fully opening the glove box and looking for the motor on top of the heater box in the upper left hand corner of the glove box opening.
Why is my Ford Ranger not getting heat?
Colin. As Colin found out, the reason he wasn’t getting any heat wasn’t due to a bad heater core, it was from a broken blend door. The blend door problem is common on the 1993-1997 Ford Ranger as well as some of the other Fords. The Ranger is built with a Blend Door to control the heater and AC function.
Where is the actuator motor on a Ford Ranger?
You can access the actuator motor by fully opening the glove box (squeeze the sides of the box and pull out). The motor is located on top of the heater box behind the glove box door. There are two motor attachment schemes used on Ford. The older models used screws mounting the motor directly to the plenum box.
Where is the hose on a Ford Ranger evaporator?
You can’t post conmments that contain an email address. SOURCE: Evaporator drain hose clogged. Cannot find to clean out. Should be underneath the car around the area in front of where your front passengers feet are. A short rubber hose, sticking out of the firewall.
There are two motor attachment schemes used on Ford. The older models used screws mounting the motor directly to the plenum box. Access the motor by fully opening the glove box and looking for the motor on top of the heater box in the upper left hand corner of the glove box opening.
Colin. As Colin found out, the reason he wasn’t getting any heat wasn’t due to a bad heater core, it was from a broken blend door. The blend door problem is common on the 1993-1997 Ford Ranger as well as some of the other Fords. The Ranger is built with a Blend Door to control the heater and AC function.
You can access the actuator motor by fully opening the glove box (squeeze the sides of the box and pull out). The motor is located on top of the heater box behind the glove box door. There are two motor attachment schemes used on Ford. The older models used screws mounting the motor directly to the plenum box.
Where are the air conditioners in a ranger station?
These work the vent/defrost and floor, respectively. There’s also one behind the glove compartment that operates the in-cab air recirculation.
