Where is the governor located on a Club Car golf cart?
Where is the governor located on a Club Car golf cart?
The governor generally sits on top of the engine. This is the easiest way to find the carburetor. Once you’ve followed the cable up to the governor, disconnect it there as well. You can save this cable for later use or throw it away.
How do I know if my golf cart has a governor?
Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor’s springs.
How do you turn off the governor on a club car?
Look behind the governor to find a small metal rod that’s permanently attached to the club car and stretch your rubber band enough to connect it to that metal rod. Screw the plastic plate back in place. Once the plate is back in place, the governor is disabled.
How can I make my club car faster?
Increase Speed On A Golf Cart
- There are simple ways to increase the speed of your Club Car golf cart.
- For example, you could start by upgrading the controller, adding a heavy-duty forward reverse switch, then upgrade the existing motor, install a solenoid, battery, cables and—well, you get the idea.
Where is the governor on a golf cart?
Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor. Locate the governor spring in the engine of the cart next to the governor arm.
Where is the spring governor on a club car?
If the club car has a spring governor, it is located near the carburetor or it is sticking out from the differential as a pivot point. The easiest way to find it is to trace the biggest, thickest cable running from the gas pedal. Once the governor is located, use a wrench or screwdriver on the spring to loosen the tension.
How to remove spring accelerated governor from golf cart?
1 Remove the rear inspection panel from the golf cart. The spring accelerated governor is right below this panel. 2 Use a 10mm wrench and tighten the nut a little by moving it in to expose the threaded rod a little more. 3 Take the cart for a test drive to check for the desired speed.
How do you adjust the motor on a golf cart?
Remove the seat and plastic covering over the engine. Sometimes you’ll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don’t have a central governor spring, you can still get your cart to move a little faster.
Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor. Locate the governor spring in the engine of the cart next to the governor arm.
How do you disable a governor on a club car?
The method to remove or adjust a governor on a club car varies depending on the type of governor the car has. It is dangerous to disable a governor completely on a club car because there is a strong chance of damage to the engine. A safer method to gain speed in a club car is simply to adjust the governor’s settings.
1 Remove the rear inspection panel from the golf cart. The spring accelerated governor is right below this panel. 2 Use a 10mm wrench and tighten the nut a little by moving it in to expose the threaded rod a little more. 3 Take the cart for a test drive to check for the desired speed.
How to remove the governor and rev limiter on a gas club?
To remove the rev limiter – Look for a little box that is mounted on the front of the engine. In that area there is a black wire that is grounded by a screw to metal. Remove the screw holding the black wire and tie electrical tape around the black wire. *Max revolutions per minute on this engine is 4000RPM. Up Shortly.
