Where is the front bumper on a Chevy Blazer?
Where is the front bumper on a Chevy Blazer?
The front bumper on a Chevy Blazer is the metal beam going across the lower front end of the frame. There are commonly 4 bolts holding the front bumper onto the frame. You will need a ratchet set to remove the bolts that are holding the front bumper to the frame.
How do you remove a front bumper cover?
Under the Bumper cover there are 4 plastic pins that need to be remove. 2 in the middle one on the left and right of the Bumper Cover. Push up on the bumper cover to reveal a small gap. Take the pliers and gently wiggle them (all 4) back and forth while pulling down but not to hard you will damage the pin if you pull to hard.
Do you need a car jack for a Chevy Blazer?
You will need a ratchet set to remove the bolts that are holding the front bumper to the frame. You will not be needing a car jack to lift the front end, however, because the Chevy Blazer is high enough that you can slide under the frame to get to the inner side of the bumper. Park the Chevy Blazer on a flat surface and set the parking brake.
What’s the best way to install a car bumper?
Take the pliers and gently wiggle them (all 4) back and forth while pulling down but not to hard you will damage the pin if you pull to hard. Gently push the screwdriver pulling the box towrds you. Make sure you do not drop the Bumper!! Reconnect the Boxes on the left and right of the bumper. Install the Headlights and Grille and your done!!!
The front bumper on a Chevy Blazer is the metal beam going across the lower front end of the frame. There are commonly 4 bolts holding the front bumper onto the frame. You will need a ratchet set to remove the bolts that are holding the front bumper to the frame.
You will need a ratchet set to remove the bolts that are holding the front bumper to the frame. You will not be needing a car jack to lift the front end, however, because the Chevy Blazer is high enough that you can slide under the frame to get to the inner side of the bumper. Park the Chevy Blazer on a flat surface and set the parking brake.
How do you remove a front bumper on a car?
Have your helper hold the front bumper tightly so that when you remove the next set of bolts the front bumper won’t fall on you. Remove the upper bolt on the right and left side of the bumper. With your helper, pull the front bumper off of the frame and set it down on a clean surface.
Where is the grille on a Chevy S-10?
The Chevrolet S-10 truck (and variants) has a one-piece plastic grille that can be easily removed by the average backyard mechanic in about seven minutes. Raise the hood and remove the four bolts that hold the top of the grille in place. They are on the top section of the grille plastic, where it connects to the top of the engine compartment.
Do you need to remove the grille on a truck?
Remove the grille. With the turn signal bulbs free, the entire grille will come out towards the front of the truck. It is not necessary to remove the headlights, but doing so might improve access to the turn signal bulbs. They are held in place with large plastic pull tabs inserted into the top of their housings.
