Where is the drive belt tensioner on a Dodge Ram?
Where is the drive belt tensioner on a Dodge Ram?
Locate the drive belt tensioner on the front passenger’s side of the engine. Use a large 3/8″ ratchet (or drive belt tool) and rotate the pulley to the right to release the belts tension. Slide the belt off the accessories and inspect it for damage to deem it reusable. The idler pulley is directly to the right of the drive belt tensioner.
How do you remove a serpentine belt tensioner?
Step 1 – To begin, some front wheel drive vehicles need to have the engine supported before tensioner removal. Rear wheel drive vehicles can omit step 1 through 4. Step 2 – Once the engine is safely supported, remove engine mount retainer nuts. Step 3 – Next, remove the main engine mount bolts, the engine will become loose during this step.
How do you tighten a power steering belt?
Using a screwdriver, pull the pump away from the mount once the power steering belt is in position to give the proper tension to the belt. When the proper tension on the power steering belt has been achieved, use a wrench to tighten the upper bolt. After doing this, the lower bolt should be tightened next.
What happens when a belt tensioner goes bad?
When the spring tension is lost in a failed tensioner it will cause squeaking especially under acceleration. A belt tensioner is a normal wear item and should be inspected regularly.
How to change the belt tensioner on a Dodge Caravan?
Place the serpentine belt around the tensioner pulley and let the tensioner move back into position to tighten the belt. Make a note of how the serpentine belt winds around the pulleys before taking it off to make it quicker to reattach. To prevent burns, let the Dodge Caravan motor cool down before attempting to change the belt tensioner.
Step 1 – To begin, some front wheel drive vehicles need to have the engine supported before tensioner removal. Rear wheel drive vehicles can omit step 1 through 4. Step 2 – Once the engine is safely supported, remove engine mount retainer nuts. Step 3 – Next, remove the main engine mount bolts, the engine will become loose during this step.
When the spring tension is lost in a failed tensioner it will cause squeaking especially under acceleration. A belt tensioner is a normal wear item and should be inspected regularly.
