Where is the crash sensor on a sur-Ron?

The crash sensor is located under the top part of the controller, if you have disabled the brake & kickstand sensors, adjusted the throttle and checked the connector and you still get cutouts (without ever loosing power to the dashboard and lights) then best would be to unplug this sensor and test the bike.

What causes a car engine to run slow?

Check the oil using your engine’s dipstick. If your oil is old, dirty or thick, this may cause the engine to run slowly and not be properly lubricated. Not only is this not ideal for your engine run quality, but this may also damage internal engine components.

How to troubleshoot sur Ron light-bee electrical troubleshooting?

Remove the 2 bolts holding the USB/ignition assembly and pull from the top, you should have a simple connector with 2 wires, unplug it and measure the continuity between the 2 pins when the switch it ON, if you don’t hear a beep them it’s possible the switch is finished.

Why is my diesel engine not working at high RPM?

Restricted air intake: This could be caused by a dirty, incorrect, or collapsing air filter inlet ducting. Advance mechanism stuck in injection pump. Vacuum being caused in fuel tank: To correct this, take the fuel cap off and see if there is a change in the operation of the engine.

When does an engine stop running for no reason?

III. My Engine Stalls Sometimes an engine may die for no apparent reason. The conditions under which it stalls can give you some clues about where the potential problem may be located. For example, the engine may stop running during idle or deceleration.

How to troubleshoot a sur-Ron brake cut out signal?

6) Rear or front light is pulling the brake cut-out signal. Disconnect both wires off the rear light and disconnect the front head light (front head light connector is located under the ignition housing). Make sure the 2 rear light wires are not touching anything.

Where is the crash sensor on a sur-Ron?