Where is the C code on a Ford Explorer?
Where is the C code on a Ford Explorer?
Pin 14 at the apim goes to pin 4 at the camera and pin 15 at the apim goes to pin 3 at the camera Ford Mechanic: HDGENE, Ford Senior Master/Diesel/Trans replied 2 years ago I dont see a C code, but a U1001 code for the a loss of commmunication.
How much does it cost to repair a Ford c1001 code?
The cost of diagnosing the C1001 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What should I do about my 2014 Ford Explorer?
Ford dealers recommend replacing or rebuilding rear brake pads, rotor and calipers. The vehicle jumping gears notice transmission failure in the 2014 Explorer without issuing a warning.
What kind of engine does the Ford Explorer have?
The 2014 Ford Explorer has a 290-hp V6 standard engine, with the explorer sport model boasting twin-turbo v6. The Two engines are featured to six-speed auto-transmissions with manual code. It’s a desirable Explorer model from the previous generation due to standardized fuel systems and well-covered car seats.
Pin 14 at the apim goes to pin 4 at the camera and pin 15 at the apim goes to pin 3 at the camera Ford Mechanic: HDGENE, Ford Senior Master/Diesel/Trans replied 2 years ago I dont see a C code, but a U1001 code for the a loss of commmunication.
The cost of diagnosing the C1001 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What is the backup camera on a Ford Explorer?
My backup camera was intermittent and is now completely inop showing on the radio screen “camera unavailable please contact your dealership”. It has a c1001 dtc.
What to do if your Ford Explorer camera is not working?
Ford Mechanic: HDGENE, Ford Senior Master/Diesel/Trans replied 2 years ago Hello, the most common issue is the camera itself, but you could have a wiring problem also, If you are trying to work around the harness, your best bet would be to overlay/run new wiring on your own from the camera to the module up front.
