Where is the 60 pin connector on a 1994 Ford Ranger?
Where is the 60 pin connector on a 1994 Ford Ranger?
1994 2.3L Ford Ranger 60 Pin Connector is Pin #53 (Purple / Yellow). You can do this mod at the transmission plug instead if you want (probably easier). Locate the oval-shaped connector on the passenger side of the transmission.
Where is the power distribution box on a Ford Ranger?
The power distribution box is located in the engine compartment near the battery. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
Where is the lock up switch on a Ford Ranger?
So in order to install a switch to force lockup, all you have to do is hook up a grounding circuit. 1) Locate pin #53 on the ECU. They are numbered on the ECU. 2) Tap into the pin #53 wire in the engine management harness.
Where is the Battery Saver relay on a Ford Ranger?
Battery Saver Relay, Auxiliary Relay Box, Restraint Central Module (RCM), Generic Electronic Module (GEM), Instrument Cluster Power distribution box Ford Ranger 2001-2009. The power distribution box is located in the engine compartment.
Where is the negative cable on a Ford Ranger?
If your looking from the front of your truck it will be located on the drivers side fender. It will have several wires going to it. I recommend you disconnect the negative cable from th battery and change the relay out.
The power distribution box is located in the engine compartment near the battery. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
What’s the problem with my 1996 Ford Ranger?
I have a 1996 Ford Ranger, I changed my starter and starter relay, got a new battery but it still wont start. the lights and radio work just fine. it does make a clicking noise any idea what may be wrong? 221 people found this helpful. 34 people found this helpful.
What makes my 2002 Ford Ranger not start?
Have a 2002 Ranger that the ignition tumbler broke,,replaced tumbler now when switched on all gauges come on,lights but when switched on to start position just getting clicking sound at relay,,jumping starter from underneath starter will ingage,,just clicking at module when turning with key 17 people found this helpful. i had the same issue
