Where can I get a new ignition module?

Chevy trucks, GMC trucks, or any General Motors vehicle with this type of eight-cylinder engine will be the same. If you drive a different vehicle, the process will be very similar. First, get a new ignition control module for your vehicle. These can be found both in physical stores and junkyards.

Is the ignition module the same on a GMC Truck?

How to replace a GM ignition module liveabout?

The grease was included with your replacement ignition module. Apply a liberal coat before you start the process of installing the module. Attach the two screws to your new ICM and reinstall the wiring harnesses. Next, reinstall your distributor cap. Aren’t you glad you don’t have to put all of those plug wires back now?

Do you remove distributor cap on ignition module?

You will need to remove the distributor cap to access the ignition control module, but do not remove all of those plug wires! It’s not a necessary step and there’s always a real chance that you’ll screw up the firing order when you reinstall them and have to go back to square one. Leaving them attached to the distributor cap is a much easier move.

Where do you replace the ignition control module?

But whatever your vehicle model, follow these steps to replace the control module in your car. Park your vehicle in a safe place and locate the ignition module. Look under the dashboard. If yours is mounted here, unplug the module wiring harness.

How to replace Ignition Control Module on LT1 Firebird?

This video shows how to replace the Ignition Control Module on a 4th Generation Firebird Trans-Am equipped with LT1 Engine. These steps are similar for all other 4th generation Firebirds and Camaros as long as they are equipped with an LT1 Engine. Loading…

How do you replace an ignition switch on a car?

Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.

Where can I get a new ignition module?