Where are the wires on a Chevy Cavalier?

Where are the wires on a Chevy Cavalier?

There is a gray wiring harness / connector on the driver side under the air intake tube.It must have 16-24 wires going in and out of it. He shook it and it started.

What kind of problem does my Chevy Cavalier have?

Have a 97 Z24. Came out to the car after work, wouldn’t start. Good battery, had headlights, windows, no radio, no signal lights. My brother is a mechanic. He met me at work and traced the wires. There is a gray wiring harness / connector on the driver side under the air intake tube.It must have 16-24 wires going in and out of it.

Is there a Chevy Cavalier ignition switch recall?

There is a recall on 2001 in the serial range, it will be installed for free and if the ignition switch is bad it will be replaced for free. Now was yours done, from the small purple wire from the starter relay there will be a splice and the wire will go up to radiator support to the relay.

How to troubleshoot a Cavalier radiator fan that is not working?

Install a jumper wire to the red wire at the harness connector and the black wire to ground. Touch the red jumper to battery positive side and the fan should operate if it is not burnt out. If it does not come on, check the connection for a good power and ground on the jumpers. If the connections are good, replace the fan.

Can you cut the yellow wire on a Chevy Cavalier?

Yes, cutting the yellow wire will do it. If you disconnect the battery you need to reset it. I have the same problem with my 2001 Chevy Cavalier. I followed all of the steps including the wire cuts with no success. My car is still locked. Can anyone help me? The yellow wire is supposed to be cut with the engine running.

What is the fuse box diagram for a Chevy Cavalier?

Here you will find fuse box diagrams of Chevrolet Cavalier 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

How do you remove an engine from a Cavalier?

Loosen the clamps on the upper and lower radiator hoses at the engine. Remove the hoses from the engine, then tuck them under the frame or behind the radiator to keep them out of the way. Remove the fuel feed and return lines from the engine, using the appropriate line wrench. Remove the coolant pipe assembly, using the appropriate wrench.

There is a recall on 2001 in the serial range, it will be installed for free and if the ignition switch is bad it will be replaced for free. Now was yours done, from the small purple wire from the starter relay there will be a splice and the wire will go up to radiator support to the relay.