Where are the fuses in the Yukon XL?

See other GMC Yukon / Yukon XL: Cigar lighter (power outlet) fuses are located in the Engine compartment fuse box (see fuses “AUX PWR”, “CIGAR” / “CIG LTR” and “LBEC”), and since 2003 in the Passenger compartment fuse box (fuse “AUX PWR 2”).

What causes heated seat light to go off in GMC Yukon?

Also when the drivers heated seat button gets pushed loud buzzing noise, causes rear drivers passenger door light to come on buzzing goes away and heated seat shuts off, on passenger side too.

How to get a GMC Yukon owner manual?

GMC Yukon/Yukon XL Owner Manual – 2013 – CRC 2nd edition – 8/15/12 Black plate (1,1) In Brief 1-1 In Brief Instrument Panel Instrument Panel Overview …. 1-2 Initial Drive Information Initial Drive Information ….. 1-4 Remote Keyless Entry (RKE) System ….. 1-4 Remote Vehicle Start …. . . . . . 1-5 Door Locks ….. 1-5

What are the warning signs on a GMC Yukon?

Danger, Warning, and Caution Warning messages found on vehicle labels and in this manual describe hazards and what to do to avoid or reduce them. Litho in U.S.A. Part No. 23476165 A First Printing©2016 General Motors LLC. All Rights Reserved.

Also when the drivers heated seat button gets pushed loud buzzing noise, causes rear drivers passenger door light to come on buzzing goes away and heated seat shuts off, on passenger side too.

What is the owner’s manual for a GMC Yukon?

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./ Canada/Mexico-11349262) – 2018 – crc – 6/20/17 6 In Brief Instrument Panel GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./ Canada/Mexico-11349262) – 2018 – crc – 6/20/17 In Brief 7 1. Air Vents0185. 2. Head-Up Display (HUD)0154 (If Equipped). 3.

Can a GMC Yukon draw a volt meter?

Yes the DVD/Nav does draw for a period of time on start-up/door open and for about 30minutes after turning the vehicle off. It then times out. My electrical guy was able to place a volt meter on the car over night and record the draw. This was huge in helping to narrow down my problem.

Are there any problems with the GMC Yukon Denali?

Issues now the dealer has not been able to rectify after numerous trips to them. Traction Active engages randomly even though unit is not slipping causing no power and just revs, not good when taking a left at a light! Have to take foot off of gas.

Why is my GMC Sierra air conditioner not working?

On a 03-07 Chevrolet/ GMC Truck with the Electronic Climate control, Removing and reinstalling the HVAC fuse, causing the electronic climate control to RESET seems to Remedy the condition in which no power is getting to the AC compressor clutch connector, thus causing the Air conditioner not to work. Will this last forever?

Where is the fuse for the compressor relay?

In addition to the 40 amp fuse that directly powers the compressor, there is also a fuse that powers the primary side of the compressor relay. It is located in the same fuse block, it is a 10 am fuse number 54. In addition to these two fuses there is the main power fuse for the suspension module.

When did the GMC Yukon XL come out?

In this article, we consider the second-generation GMC Yukon / Yukon XL, produced from 2000 to 2006. Here you will find fuse box diagrams of GMC Yukon 2000, 2001, 2002, 2003, 2004, 2005 and 2006, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

How is the compressor clutch relay turned on and off?

In some vehicles the compressor clutch relay is turned on and off by the low pressure switch and the evaporator temperature sensor. In a computer controlled system, the compressor clutch relay is grounded by the computer. If the fuse is good, disconnect the electrical connector from the compressor clutch coil.

Why does my AC compressor clutch not engage?

Why AC clutch won’t engage If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways.

Where is the fuse box on a GMC Sierra?

The fuse block access door is on the driver’s side edge of the instrument panel. The center instrument panel utility block is located underneath the instrument panel, to the left of the steering column. The underhood fuse block in the engine compartment on the driver’s side of the vehicle near the battery.

Where is the underhood fuse / relay center located?

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

Where is the relay on a 2003 Silverado?

Seems like a Relay starting to go bad. The Orignal part# that I pulled out from my 2003 Silverado is 15764153. 2/4-W/Opt. Trailering. This relay is found behind the fuse panel on the left side of the dash.

Where is the turn signal on a GM Truck?

This relay is found behind the fuse panel on the left side of the dash. The easiest way to get to it is Pull the plastic trim around your gauges. You can do this by lowering the steering wheel as low as it can go and then moving the shift lever down all the way. You’ll have to use your key, turn on and then lower. Then carefully pop the trim.

What to do if your car fuse box stops working?

Some cars have multiple fuse boxes with many different fuses. If something electrical in your vehicle suddenly stops working, start by checking the fuse box and get a certified mechanic to take a look and diagnose any electrical problems. Most cars have more than one fuse box – some vehicles may even have three or four.

Why are the brake lights not working on my GMC Yukon?

If your Yukon’s brake light switch checked out ok, and there are no brake lights illuminating at all, inspect the wiring harness going from the brake switch to the bulbs themselves. There could be an issue with frayed wiring, wiring that has lost its ground, or a short/open situation.

Are there any recalls on GMC Yukon Denali?

The 2006 GMC or Cadillac Yukon Denali has a recall, technical service bulletins (TSB) and safety reports about the stability control on the SUV. Read more: Problems With the Traction Control on a 2006 Yukon | eHow.com http://www.ehow.com/list_7635921_problem… http://www.ehow.com/list_7635921_problem… Was this answer helpful?

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. *1 — Gasoline Engine and Fuel Injection Rail #2.

How do you turn off the cel light?

Wait about 10 seconds. Fully depress the accelerator pedal and keep it for more than 10 seconds. Fully release the accelerator pedal (The CEL light will continue to blink). Turn ignition switch to On position and now you can start the car. The CEL light should be gone. Turn ignition Off.

How to reset your check engine light ( CEL ) manually?

Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking. Wait about 10 seconds. Fully depress the accelerator pedal and keep it for more than 10 seconds. Fully release the accelerator pedal (The CEL light will continue to blink).

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. *1 — Gasoline Engine and Fuel Injection Rail #2.