When was the 351 Windsor small block made?
When was the 351 Windsor small block made?
351 Windsor Small Block The 351 Windsor (351w for short) is the largest of the Ford Small Block engine family. Ford Motor Company built them between 1969 and 1996. It’s a 90 degree V8 with an overhead valve train.
What’s the difference between a 351 Windsor and 351 m?
The 351M is closer to the Cleveland than the Windsor but is basically a de-stroked version of the big block 400, a different block altogether with a taller deck height than either the Windsor or the Cleveland (at 10.297). The M also shares a bellhousing pattern with other members of the 335 big block engine family.
When was the 351 Windsor bullnose casting made?
A casting that starts with C90E was built in 1969 because the C signifies the 60’s and the 9 is for the last year of that decade. The O signifies that it was built for a Torino and the E stands for Engine. Castings that start with D are built in the 70’s, E in the 80’s, and F in the 90’s.
What are the casting numbers for a Ford engine?
Whether it’s for a correct restoration, or a budget build, sometimes an original FoMoCo engine block is what you’re looking for. Whether you’re scouring the internet or junkyard, the following Ford engine block casting numbers should help you figure out what you’re looking at. Numbering Convention
What was the engine block number for the Windsor 351?
The number was C8AE-6015-B with 302 marking in the lifter valley. At the very end of the model year some additional 289 blocks must have been discovered as the older C6AE-6015-C blocks appeared again. In 1969 Cleveland continued with 302 production. Windsor dropped 289 production and took up the 351.
Where is the casting number on a Ford 351W?
Block Identification The 351W casting number is located on the right side of the block, about halfway down, facing downwards. The code will be a combination of letters and numbers — for example, “E3AE.” In this code, the E represents the decade number and the 3 represents the year.
What was the casting number for a 1967 Windsor 289?
The casting numbers for these were (C6AE-6015-C with a “289” and “WF” in the lifter valley. In 1967 both Cleveland and Windsor produced 289s using earlier year casting numbers but with updated date codes. These two blocks were interchangeable, but there were probably some minor differences.
Where does the engine block c8ae 6015-b come from?
In short: C8AE-6015-B is a 302 block from the Windsor plant that was used in 1968 on a 289. C8OE-6015-A is a 302 block from Cleveland from a 1967 289 or a 1968 or later 302 (check date code). There is no code stamped on the block itself that can be used to identify the cubic inch displacement of the block.
