Other

When did the lights go out on my Chevy Equinox?

When did the lights go out on my Chevy Equinox?

See all problems of the 2007 Chevrolet Equinox . I purchased my 2008 Equinox in March 2010; there was slight moisture building up in both headlight assemblies; now major moisture. After replacing both headlights and multiple bulbs, the entire left side went out in July 2014.

Are there any problems with the Chevrolet Equinox?

In October 2015, condensation began building up again in the driver’s side lens. We replaced a bulb in November and in February, ended up replacing the entire component due to condensation gathering in the headlight, to the cost of over $400! this is obviously a design flaw for this vehicle. See all problems of the 2007 Chevrolet Equinox .

What was the VIN on a 2008 Chevy Equinox?

The contact owns a 2008 Chevrolet Equinox. While driving various speeds, the headlights intermittently failed. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The VIN was unavailable. The approximate failure mileage was 124,000. Passenger air bags did not work, doesn’t even acknowledge a passenger.

Where are the fuse panels on a Chevy Equinox?

Here you will find fuse box diagrams of Chevrolet Equinox 2010, 2011, 2012, 2013, 2014, 2015, 2016 and 2017, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

What to do if your low beam headlights don’t work?

Cut the wires approx. 1-3/4-in. from the connector. Then splice in the new pigtail (parts numbers shown below) using the splice sleeve. Install new headlight bulb and test.

See all problems of the 2007 Chevrolet Equinox . I purchased my 2008 Equinox in March 2010; there was slight moisture building up in both headlight assemblies; now major moisture. After replacing both headlights and multiple bulbs, the entire left side went out in July 2014.

In October 2015, condensation began building up again in the driver’s side lens. We replaced a bulb in November and in February, ended up replacing the entire component due to condensation gathering in the headlight, to the cost of over $400! this is obviously a design flaw for this vehicle. See all problems of the 2007 Chevrolet Equinox .

Why are my headlights not working in high beam?

If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.

The contact owns a 2008 Chevrolet Equinox. While driving various speeds, the headlights intermittently failed. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The VIN was unavailable. The approximate failure mileage was 124,000. Passenger air bags did not work, doesn’t even acknowledge a passenger.

Where can I get a new headlight for my car?

At this point, a mechanic should be consulted. Sturtevant Auto salvage yard has a huge stock of used and replacement headlight parts for many of the most popular brands of cars and trucks, including Jeep, Chrysler, Ford, Subaru, Volkswagen, and many, many more.

What does the StabiliTrak warning light mean on a Chevy Equinox?

Description: StabiliTrak is the Chevrolet Equinox electronic stability control / traction control program to help the driver maintain control. The system is on by default which is indicated by the warning light at engine startup. This light should go out soon after, but if it doesn’t come on at all, have the system checked.

How to start a 2012 Chevy Equinox owner manual?

Chevrolet Equinox Owner Manual – 2012 Black plate (5,1) In Brief 1-5 Remote Vehicle Start With this feature the engine can be started from outside of the vehicle. Starting the Vehicle 1. Press and release Qon the Remote Keyless Entry transmitter. 2. Press and hold /for about two seconds. The turn signal lamps will briefly flash to confirm

What does the sash warning light on Chevy Equinox mean?

If this light comes on when driving, a malfunction has been detected in emissions control. On diesel versions of the Equinox, the sash warning light may also come on indicating a fault with the Diesel Exhaust Fluid (DEF) management system. What to do: Steady Light: Have vehicle serviced.

How does the remote keyless entry work on a Chevy Equinox?

Press the button on the driver door handle when the RKE transmitter is within 1 m (3 ft) of the driver door handle. When unlocking from the driver door, the first press unlocks that door; press again within five seconds to unlock all passenger doors. See Remote Keyless Entry (RKE) System Operation 0 32.

Description: StabiliTrak is the Chevrolet Equinox electronic stability control / traction control program to help the driver maintain control. The system is on by default which is indicated by the warning light at engine startup. This light should go out soon after, but if it doesn’t come on at all, have the system checked.

What happens if the dash lights stay on on a Chevy Equinox?

If either of these dash lights stay on, there’s a brake fault. The Chevy Equinox brake system consists of two hydraulic circuits. The vehicle will still stop by using one hydraulic circuit, but for best braking performance, both circuits need to be working. There is a risk to occupant and other road users safety. Have vehicle checked immediately.

What are the controls on a Chevy Equinox?

1. Air Vents0195. 2. Turn Signal Lever. SeeTurn and Lane-Change Signals 0161. IntelliBeam®System Button (If Equipped). SeeExterior Lamp Controls0157. 3. Instrument Cluster0122. Driver Information Center (DIC) Display. SeeDriver Information Center (DIC)0139.

Why do high beam headlights work but low beams don’t?

Most headlight systems are also designed with a relay that switches the power between low beam and high beam headlights. If this relay goes bad, it could allow power to the high beams, but not the low beams. 1. Headlight Bulbs This is the most common reason we see for why a car’s high beam headlights work but the low beams don’t.

Are there any problems with the Chevy Equinox headlights?

Tl the contact owns a 2013 Chevrolet Equinox. The contact stated that the headlight units were foggy and there was reduced visibility while driving at night. The dealer and manufacturer were not contacted. The vehicle was not diagnosed or repaired.

What does it mean when your headlights don’t work?

With that in mind, it can be tremendously useful to start off by looking at whether both, or just one, of your headlights have failed, and whether or not the high or low beam mode still works. When headlights stop working, it’s usually an electrical problem or an physical issue with the bulbs themselves.

What to do when both head lights stop working at the same time?

When that happens, the operational lifespan of your headlight capsule will be severely compromised, and the only fix is to replace the headlight assembly. When both headlights stop working at the same time, the bulbs usually aren’t at fault.

Why is my headlight low beam going out?

It is when the circuit is completed by plugging in the bulb it looses power. In the fuse panel, I did switch the hi/lo rely with another from the panel and still have the same results. I am able to jump it and get the bulb to come on.

Here you will find fuse box diagrams of Chevrolet Equinox 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

When did my Chevy Equinox headlight go out?

After replacing both headlights and multiple bulbs, the entire left side went out in July 2014. I took to a dealership and gm part was replaced for $350 (had work discount). My right side is building up with moisture and will eventually have to be replaced once my headlight goes out.

What should I do if my Chevy headlights are not working?

To check alignment, park about 10 feet from the garage door wall and turn the lights on. Low beams should be aimed straight forward and hit no higher than your hood line. The high beams should move slightly, but not too much higher than the low beams.

Author Image
Ruth Doyle