What tools do you need to replace serpentine belt?
What tools do you need to replace serpentine belt?
Tools/Supplies Needed:
- ratchet and socket set.
- torque wrench.
- new replacement belt.
- new tensioner.
- new pulley.
- wrench set.
- jack and axle stands or ramps.
Can I cut serpentine belt off?
Serious damage caution. Do “not” cut the belt: Avoid such a “short cut”, as that can cause the tensioner or where it attaches to be damaged when it springs back violently.
What’s the best way to replace a serpentine belt?
Auto tensioners have either a hole that will fit a half inch drive ratchet, or a bolt you can use a socket to apply pressure to. Insert the wrench or place the socket over the bolt on the tensioner and twist it away from the belt to relieve the tension on it.
How do you remove a belt from an auto tensioner?
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.
Where do I find the serpentine belt routing diagram?
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
What happens if a serpentine belt goes bad?
The serpentine belt in most modern vehicles transfers power from the crank pulley to the various accessories mounted on the engine. A worn or damaged serpentine belt can fail to adequately transfer the power, leaving your alternator, power steering, and air conditioning failing to function.
How do you repair a serpentine belt on a car?
Steps Determine repair parts needed: All moving parts are subject to failure and you may need to remove the serpentine belt to replace the belt itself or one of the components it drives. Park the vehicle in a level spot and set the emergency brake. Turn the engine off and chock the rear wheels for both directions.
Can you rent a serpentine belt removal tool?
Most auto supply stores will “rent to own” serpentine belt removal tool (the long, flat, thin breaker bar) to you at no cost, when you buy but then return it for a refund within the specified time (48 hours at some stores or a longer time at others).
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
Can a pulley belt be tightened with a serpentine belt?
Previously, these systems used multiple belts on pulley systems with a number of ways to manually tighten the belts. The serpentine belt system consists of only one belt and one automatic belt tensioner. The process is often tricky with various manufacturer’s designs, but is not very difficult and may be done using basic hand tools.
