What should I replace the throttle body on my Chevy Silverado?
What should I replace the throttle body on my Chevy Silverado?
Your Silverado’s throttle body is an air-intake butterfly valve that regulates air flow. Removing it and replacing it with a shiny, new throttle position sensor (TPS), or a new unit all together can keep your truck running strong.
Why does my Chevy Silverado not want to accelerate?
If the catalytic converter gets too clogged up, it’ll keep the motor from accelerating properly. It’ll “bog” after a certain speed. Maybe it’ll drive 20 miles an hour just fine, but after that it just doesn’t want to accelerate whatsoever. This can also be a sign that it’s not getting enough fuel as well.
What kind of throttle do I need for a Suburban 1500?
This is on my 2007 Suburban 1500 w/ the 5.3L, with 110,000 miles which has been running fine and consuming no more fuel than I’m used to… I read up on P0121 and saw that it involves the TPS integrated into my Throttle Body. I decided to clean to TB before spending ~$200 on a replacement.
Why does my Chevy Silverado not transfer power?
If your Silverado is too low on transmission fluid, it’ll will no longer be able to transfer power to the rear wheels. The power goes to the torque converter, and that’s the end of the line. You should check the transmission fluid immediately.
When to replace the throttle body on a Silverado?
I cleaned my throttle body and replaced throttle body position sensor on my 2013 Chevy Silverado 5.3L. My truck idles fine until I press the accelerator … read more
Why does my Chevy Silverado stall when idle?
I cleaned my throttle body and replaced throttle body position sensor on my 2013 Chevy Silverado 5.3L. My truck idles fine until I press the accelerator … read more Vocational, Technical or Tra… 2003 Chevy Silverado will intermittently stall and will start 5 to 20 minutes later. RPM will drop to almost nothing and then stall while idling.
How to do throttle body re-Learn Chevy Malibu?
1) Start the engine and let it idle in park for 3 minutes. During that period the idle may be higher idle than normal. 2) After 3 minutes, turn the engine off and leave it off for 60- seconds. 3) Start the engine again and let it idle in park for 3 minutes one more time. During these run periods you may see a check engine light.
How to change the accelerator pedal release position?
Accelerator Pedal Release Position Learning Procedure. Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
