What should I know before starting a caterpillar machine?
What should I know before starting a caterpillar machine?
The specifications, torques, pressures, measurements, adjustments, illustrations, and other items can change at any time. These changes can affect the service that is given to the product. Obtain the complete and most current information before you start any job. Caterpillar dealers have the most current information available.
Why is my cat 305 CR not working?
DO NOT under any circumstances use the “quick replacement” battery terminals that clamp to the cables with a couple of bolts. I ran into similar problems with an 1840 that I have. The positive post was worn to the point that it would not charge.
What are the warning signs on a caterpillar machine?
Safety precautions and warnings are provided in this manual and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. The hazards are identified by the “Safety Alert Symbol” and followed by a “Signal Word” such as “DANGER”, “WARNING” or “CAUTION”.
Why is the ignition dead on my Cat 305?
A couple times when the key in off position I could hear a buzzing coming from under the seat by the hour meter, turn key on and the buzz would quit, or when it was buzzing with key off it would quit on its own after 5 seconds or so. Now key in the on position is totally dead and in the off position there is no noises either.
What are the features of a cat 304e mini excavator?
Small Specalog for Cat 304E CR Mini Hydraulic Excavator AEHQ6555-00 FEATURES: The Cat®304E CR Mini Hydraulic Excavator delivers high performance in a compact design to help you work in the tightest applications. The 304E CR features the following: Fingertip control for the boom swing and auxiliary hydraulic functions
What was the problem with my Cat 305?
Tried key again and the same thing, kept trying the key, sometimes when key on the lights would come on, then others nothing at all when key is on.
What was the problem with my excavator this morning?
Started the excavator this morning to move it 50 feet out of the way, started fine, shut it off, about a hour later came back and tried to move it and when turning the key on it would beep, fuel needle moves, dash lights came on which is all normal but when I hit they key everything goes out and starter doesn’t engage or make any noise.
Where does power go on a cat 301.5 excavator?
With the key on and the arm rest down the power should go through the hydraulic disable relay to the M927 green wire and directly to the hydraulic disable solenoid on the manifold block under the seat. If power does not go through the relay, it is bad.
