What oil does a 2007 Ford Fusion use?
What oil does a 2007 Ford Fusion use?
The 2007 Ford Fusion needS5W-20 Synthetic Motor Oil in all temperatures for both engines. The capacity for the car iS4. 5 quarts with a filter for the 2.3 L 4Cylinder and 6 quarts with a filter for the 3.0 L V6 engine.
How do you change the oil in a Ford Fusion?
For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Fusion oil filter wrench. If your Fusion is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Fusion.
Where is the oil drain plug on a Ford Fusion?
This video shows you the location of your oil drain plug, oil filter, oil fill cap and dipstick in addition to the steps needed to change the oil and filter in your Fusion. For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Fusion oil filter wrench.
How to do an oil and filter change?
Oil & Filter Change Ford Fusion (2006-2009) – 2007 Ford Fusion SE 2.3L 4 Cyl. 1. Getting Started – Prepare for the repair 2. Open the Hood – How to pop the hood and prop it open
How do you clean the O-ring on a Ford Fusion?
Coat the o-ring with clean engine oil. Install the drain plug and tighten it with a combination wrench. If your Fusion has one, install the oil filter cover and tighten the two screws that hold it in place. Wipe up any spilled motor oil from the underside of the vehicle. Remove the jack stands and lower the vehicle.
For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Fusion oil filter wrench. If your Fusion is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Fusion.
This video shows you the location of your oil drain plug, oil filter, oil fill cap and dipstick in addition to the steps needed to change the oil and filter in your Fusion. For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Fusion oil filter wrench.
Oil & Filter Change Ford Fusion (2006-2009) – 2007 Ford Fusion SE 2.3L 4 Cyl. 1. Getting Started – Prepare for the repair 2. Open the Hood – How to pop the hood and prop it open
Coat the o-ring with clean engine oil. Install the drain plug and tighten it with a combination wrench. If your Fusion has one, install the oil filter cover and tighten the two screws that hold it in place. Wipe up any spilled motor oil from the underside of the vehicle. Remove the jack stands and lower the vehicle.
