What kind of vacuum hose does Ford Expedition have?

Title: Vacuum Hose 2004 Ford Expedition Author: Christin Wirth Subject: vacuum hose 2004 ford expedition Keywords: Read Online vacuum hose 2004 ford… Click to expand… Thank you-Really helpful! Thank you-Really helpful! Click to expand… The picture is a little different.

What does large leak mean on Ford Explorer?

While the trouble code may state that there is a “large leak” in the EVAP system of your Ford Explorer, the actual leak will most likely still look rather small. The “large” really is referring to how much pressure is being lost.

What are the common problems with Ford Explorers?

Solution: A common failure is a faulty valve body. The solution is to fit a revised valve body with intermediate plate. Problem: Knocking noises from the cooling system and the coolant temperature gauge fluctuating. Solution: The cause may be irregular flow of coolant moving through the cooling system.

What causes a transmission flare in a Ford Explorer?

Transmission problems (1997, 1998, 1999, 2000, 2001): Transmission flare when shifting from second to third gear is due to a shift solenoid malfunction.

What kind of transmission does a Ford Escape have?

I just inherited a 2001 Ford Escape with a 3.0L. The car was totaled by my sister and I decided to buy it back and fix it up as it only had a few minor issues and had a brand new transmission with less than 20,000mi on it. Well I got it all fixed up but I’m stumped by a vacuum hose that I cant figure out what it connects to.

Where is the fuel vapor hose on an escape city?

That line looks to be the fuel vapor hose from the fuel tank/charcoal canister to the EVAP valve. Leaving it unplugged probably would have thrown a code and turned on your “CEL” but the vehicle would probably run fine without it connected. The EVAP system is strictly emissions related.

Where is the bare vacuum line on a Ford Expy?

Click to expand… Below the PCM computer, passenger side. The bare vacuum line is the SUPPLY line to the dash. The shrouded line is the vacuum control line TO the hot water valve. Hello, I have a vacuum leak on my Expy leading to A/C coming through the defrost only issue.

When to replace emission hoses under the hood?

If the emission hoses under the hood of your car are original, it’s time to replace them now, rather than wait. If you wait, it can lead to air leaks and cause idle or drivability problems, and most likely some diagnostic trouble codes like a P0171 or P0174.

Can a regular vacuum line be used to replace an emissions hose?

Another thing to be aware of is that you cannot use regular vacuum hose to replace emission hoses. You must use emissions hose (or fuel line hose)on those hoses. Regular vacuum hoses just aren’t strong enough to work.

What does p0171 mean on a Ford Expedition?

The fix is a little rubber ’boot’ or elbow with a crack or a hole in it causing a vacuum leak. The Ford dealer will run a diagnostic and indicate that it returned an error code P0171 and P0174, which indicates the engine is running lean. They will most likely recommended the following service: all at a cost of almost $800. Yikes!!!!

Where is the PCV valve on a Ford Expedition?

The PCV valve is in the right valve cover… which is on the left side when your facing the engine (passenger side). It’s under a lot of other hoses so it is very hard to see..

What causes rough idle in a Ford Expedition?

You most likely have crack or hole in the little rubber elbow that connects to the intake from the PCV valve on the right hand side of engine. Even the slightest crack will allow more air to be sucked into the engine causing a too lean mixture.

What kind of engine has 4.2L vacuum hoses?

Give me a vacuum hoses routing picture for my truck XL, 4.2L gasoline engine. I greatly appreciate your previous advice. have the same problem? I found this diagram. The only f-150 with a 4.2

Where is the vacuum gauge on a Ford?

For a quick and dirty reading unplug the easy to find PCV hose on the valve cover and plug in the vacuum gauge.

Where does the vacuum line go on a Ford F150?

On the intake in the photo, the passenger side big diameter tube goes to the passenger side PCV valve in the valve cover. (unless you have a catch can installed). The smaller diameter tube pointing towards the driver’s side comes from the vacuum pump I think. It’s a long line that connects up near the master brake cylinder near the firewall.

What makes AutoZone vacuum connectors a great choice?

This allows you to transmit the vacuum across multiple systems, similar to hydraulic or pneumatic systems. Choose vacuum tubing ranging from 1/16-inch to 3/8-inch diameter. What Makes AutoZone a Great Choice? Looking for vacuum connectors and tubings near me? AutoZone has a wide selection of hose diameters and various fittings for each type.

What causes a vacuum tubing connector to wear out?

From straight couplings to t-shape and y-shape connectors, you’ll find everything you need to repair your worn-out tubing. Because vacuum tubing is made of rubber, regular use will wear it out over time. Extreme conditions can cause it to wear out quickly.

How do you replace a vacuum line in a 1994 Ford?

The green marks in the photo apply to 1994-1995 cars: I started by replacing the short section of 5/8″ hose coming off the drivers’ side valve cover. Simply twist and remove the short section of hose, lay it beside your 1ft length of 5/8″ hose, and cut so the length is approximately the same.

Are there color coded hoses on a Ford V8?

According to the factory Ford service manual, some (or all?) vacuum hoses are color coded. The manual mentions red and green striped hoses but I couldn’t tell if my lines had stripes or not, they were too old. For our purposes we don’t need the color stripes anyway.

How do you replace the emissions hose in a Ford?

Simply twist and remove the short section of hose, lay it beside your 1ft length of 5/8″ hose, and cut so the length is approximately the same. It doesn’t have to be exactly the same length but keep it close to the same length to make it easier. Ideally you should use emission hose here, however using the heater hose isn’t a big deal.

Where does the vacuum line go in a Ford firewall?

Easiest way to find out is crank the car. The vacuum line that should go into the grommet will have vacuum (you can feel the vacuum sucking by putting your finger on it). Hope this helps View attachment 52532 View attachment 52532

Where does the drain tube end on a Ford Expedition?

The tube terminates behind a metal panel near the wheel well under the truck. There is no direct line of sight to check it visually, I would try one of the methods above. The sunroof drain tubes end inside the bottom of the front fender, right where it meets the front door.

Where does the vacuum hose go in a firewall?

The small plastic vacuum hoe that goes into the firewall goes into a big rubber grommet first. Inside that grommet is another rubber hose that the first plastic hose goes into. To see this you have to remove the battery. Problem fixed, good cold air! Great! Glad it’s fixed.

What happens if you leave a vacuum line Unplugged?

Leaving it unplugged probably would have thrown a code and turned on your “CEL” but the vehicle would probably run fine without it connected. The EVAP system is strictly emissions related. Now, if you had left a vacuum line unplugged from the engine to the EVAP solenoid, then you’d have a vacuum leak and driveability issues.

Where can I buy parts for my Ford Expedition?

High-quality auto parts are what repair techs need to keep that Ford running well however tough the environment. If you want Ford Expedition parts, it’s good sense to find only top-notch OEM and aftermarket parts on the market – and at Parts Geek you’ll find affordable prices on or off the Internet all handled with world class service.

When did the Ford Expedition get its name?

The Expedition is the third vehicle to use that name–its first use was on a 1992 F-150 Eddie Bauer Expedition, a concept vehicle. It was also used for a brief time during the 1995 model year for one of the trim levels of the Ford Explorer Sport.

Is the Ford Expedition a high quality car?

A Ford Expedition is regarded as a high-quality vehicle but with wear the best-engineered vehicles must have periodic maintenance and repair. High-quality auto parts are what repair techs need to keep that Ford running well however tough the environment.

Are there any problems with the Ford Expedition?

While the latest generation resolved most Ford Expedition engine problems, some drivers have complained about faulty throttle bodies in the 2017 Expedition and the 2016 model year’s engine dying or surging while driving. Among these issues, faulty Ford Expedition fuel injectors are considered the worst.

How many seats does a Ford Expedition have?

It was also used for a brief time during the 1995 model year for one of the trim levels of the Ford Explorer Sport. The Expedition offered seating for up to nine passengers in pre-2007 model years while 2007 and newer models have bucket seats in the first row.

How long does it take to ship a Ford vacuum hose?

Only 8 left in stock – order soon. . . Only 5 left in stock – order soon. . Only 9 left in stock – order soon. . . Only 9 left in stock – order soon. . Usually ships within 5 to 7 days. .

What kind of transmission does a Ford Aerostar have?

Ford Automatic Transmission Application Guide Model Years Engine Type / Size TYPE AEROSTAR 95 V6 3.0L/4.0L A4LD AEROSTAR 96-97 V6 3.0L 4R44E AEROSTAR 96 V6 4.0L 4R55E AEROSTAR 97 V6 4.0L 5R55E

Where are the vacuum lines on a Ford?

The 2 lines under the hood stick into holes in the grommet…and on the backside, there are 2 vacuum lines attached that run to the controls on the dash. All you should have to do is stick the line that has become detached back in the hole in the grommet.

What kind of vacuum hose does Ford Expedition have?