What kind of axle shaft does a Ford Explorer use?

What kind of axle shaft does a Ford Explorer use?

Ford Explorer (1991-2001) (The Ford Explorer Sport still used the solid rear 8.8 until 2003) Axle Shaft Splines: Ford Mustang – The Ford Mustang 8.8-Inch axle from 1986-2004 used 28-spline shafts. From 2005 and on, the Ford Mustang 8.8-Inch axle used 31-spline shafts.

When did Ford Explorer get the 8.8 inch axle?

Ford Explorer: The 8.8-Inch axle came in Ford Explorers (and Mazda Navajo) in 1990 as a 1991 model year. The Ford Explorer used it until it switched to an independent rear suspension in 2002. The exception is the 2002-2003 Ford Explorer Sport which still used the solid rear 8.8-Inch axle.

When did Ford Explorer switch to independent rear suspension?

It came in Ford Explorers (and Mazda Navajo) in 1990 as a 1991 model year. The Ford Explorer used it until it switched to an independent rear suspension in 2002. The exception is the 2002-2003 Ford Explorer Sport which still used the solid rear 8.8-Inch axle.

What kind of engine does the Ford Explorer have?

With EcoBoost power, today’s Ford Explorer gets excellent fuel mileage while still being a powerful utility vehicle that consumers can rely on. It comes standard with a 3.5-liter V-6 engine with an output of 290 horsepower, but consumers can opt for a turbocharged four-cylinder engine for more power and performance.

What kind of rear axle does Ford Explorer have?

The Ford Explorer 8.8-Inch rear axle has found homes in numerous vehicles besides the Explorer. It has been swapped in to Ford Rangers, Bronco II’s, Jeeps, Chevy S-10’s and even some cars. The 8.8-Inch axle used in the Explorer is highly desirable because it came with 31-spline axles over the typical 28-spline found in the Ranger version.

Is there a driveshaft for the Ford Explorer?

From extra cargo space and comfortable seating to innovative features and reliability to boot, your SUV gives you a dependable ride, every time. Keep it as steadfast as possible by installing a new Ford Explorer driveshaft from AutoZone today.

Can a 1990 Ford Explorer drive a 1990 Ranger?

Pre-1990 Ranger Driveshafts Will Not Bolt Directly Up To The Explorer 8.8 (Have Custom Shaft Made Or Get A 1990 Or Newer Shaft) Rather than welding the tubes into the diff housing, the tubes are just held in with pressed-in plugs.

What’s the difference between a Ford Explorer and a Ford Ranger?

The 8.8-Inch axle used in the Explorer is highly desirable because it came with 31-spline axles over the typical 28-spline found in the Ranger version. There’s a 20-25 percent difference in strength between this Explorer 8.8 and the Ranger 8.8.

What’s the difference between Ford Ranger and explorer 8.8?

EVERYTHING in the Ranger 8.8 and Explorer 8.8 is the same size (carrier bearings, pinion bearings/seals, ring gear, pinion, pinion nut, ring gear bolts, top and bottom spider gears) EXCEPT the side spider gears (the Ranger one has 28-splines and the Explorer has 31-splines), and the cross pin.

What kind of wheel pattern does a Ford Ranger have?

Mustang Note: Mustang owners have been known to take the left axles from 1990-1992 Ford Ranger 8.8-Inch axles to convert their axles from a 4-lug to a 5-lug wheel bolt pattern, or to replace an axleshaft. Wheel Bolt Pattern: Ford Rangers, Explorers and Mustangs have a 5×4.5 wheel bolt pattern.