What is the Technical Manual for a John Deere backhoe loader?

TM10131 – John Deere 310SJ Backhoe Loader (S.N. -159759) Technical Manual (Operation & Test).pdf Complete technical manual with Electrical Wiring Diagrams for John Deere 310SJ Backhoe Loader (S.N. -159759), with all the shop information to maintain, diagnostic, repair, service like professional mechanics.

What’s the difference between John Deere 310sj and 310E?

The 310SJ also comes with a powershift transmission which has four gears moving forward and three in reverse. In contrast to the John Deere 310SJ, the John Deere 310E has a far smaller range of motion on its backhoe; its load height is 10 feet 9 inches, its swivel reach is 17 feet 8 inches, and its dig depth is 14 feet 3 inches.

What kind of engine is 310jand310sj backhoeloader?

BackhoeLoader 310Jand310SJ Engines4045DT060, 4045HT054and4045TT094 *OMT210365* 310Jand310SJBackhoeLoaders OPERATOR’SMANUAL Engines4045DT060,4045HT054 and4045TT094

What are the parts of a John Deere backhoe?

The bucket cylinder, boom cylinder, dipper cylinder, and outrigger or stabilizer cylinder are all built to interchange directly with the OEM backhoe hydraulic cylinders so that every part of each cylinder will match original equipment parts available from any John Deere dealer.

BackhoeLoader 310Jand310SJ Engines4045DT060, 4045HT054and4045TT094 *OMT210365* 310Jand310SJBackhoeLoaders OPERATOR’SMANUAL Engines4045DT060,4045HT054 and4045TT094

Why does the bucket on my tractor not uncurl?

While using the tractor the other day, I accidentally dug the edge of the bucket into the ground while driving forward at speed. The hit was pretty hard, and my chest slammed into the steering wheel. After that impact, the bucket no longer un-curls. It curls fine.

Is there a hydraulic problem with a John Deere backhoe?

Discussion in ‘ Tractor/Loader/Backhoes ‘ started by Craig Pondish, Jun 12, 2018 . I bought a JD 310SE at an auction, that has a hydraulic problem. The backhoe seems to work to some degree, not optimal, but the loader will barely move.

Why is my John Deere 310se not getting hot oil?

Note that the rest of the valve is not getting that hot oil, so it doesn’t get hot, so the oil is going from the pump to the inlet of the valve and back to the tank. I took two relief valves apart and cannot see anything wrong with either.

How to troubleshoot hydraulics in a John Deere tractor?

These include applying brakes or operating Selective Control Valve. To solve this issue, you should connect the hydraulic motor to a 300 Series SCV with a compensator valve to control pressure variation. You should also consider adjusting oil flow through the Selective Control Valve either at or below the maximum oil capacity of the motor.

What causes a John Deere tractor hose tip to fail?

Male tip failures may be as a result of the internal poppet or ball stop being damaged or moving out of position. For the female coupler, internal seal failure may cause the male hose tip not to open, causing female coupler failures. In case you cannot fix the problem on your own, you should see a John Deere dealer for SCV coupler repair.

What causes a John Deere tractor to creep forward?

You may also notice low hydrostatic charge pressure, a noisy system pump, low system pump oil flow, no system pressure, and a machine that creeps forward or reverses. It is important to understand the factors that could lead to the machine problems mentioned above.

What is the Technical Manual for a John Deere backhoe loader?