What is the OBD code for Mercury check engine light?
What is the OBD code for Mercury check engine light?
Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. Manufacturer Specific Codes P1000OBD System Readiness Test Not Complete P1001KOER Test Cannot Be Completed P1039Vehicle Speed Signal Missing or Improper
Where are Ford code 11 and 12 located?
Record all codes received. Turn ignition “OFF”. Ford DTC’s (Diagnostic Trouble Codes) Data Link Connector (DLC)(Located Under hood) Analog Voltmeter Connection Ford Codes 11 System PASS. 12 Cannot control rpm during KOER Sell-Test high rpm check.
Where can I find the Mercury diagnostic code?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. Manufacturer Specific Codes P1000OBD System Readiness Test Not Complete
Which is the correct code for Mercury check engine light?
1 Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. 2 Manufacturer Specific Codes 3 P1000 4 P1001 5 P1039 6 P1051 7 P1100 8 P1101 9 P1105 10 P1106
What are the codes for Ford check engine light codes?
81 Secondary -Air Injection Diverter (AIRD) solenoid circuit failure. 82 Secondary Air Injection Bypass (AIRS) solenoid circuit failure. 84 EGR Vacuum Regulator (EVR) circuit failure.
Record all codes received. Turn ignition “OFF”. Ford DTC’s (Diagnostic Trouble Codes) Data Link Connector (DLC)(Located Under hood) Analog Voltmeter Connection Ford Codes 11 System PASS. 12 Cannot control rpm during KOER Sell-Test high rpm check.
Where are the OBD1 trouble codes located on a Ford?
Ford vehicles manufactured before 1996 are equipped with the OBD1 diagnostic system which is unique in the way trouble codes are retrieved. Each Ford car before 1996 has the data connector in a different place such us under the hood near the left fender or close to the cowl on the right side. It can be hidden by a cover or a dead end connector.
What kind of car is the Mercury Topaz?
The Mercury Topaz is a compact car that was sold by the Mercury division of Ford Motor Company from 1984 to 1994 as a slightly upscale variant of the Ford Tempo.
Ford vehicles manufactured before 1996 are equipped with the OBD1 diagnostic system which is unique in the way trouble codes are retrieved. Each Ford car before 1996 has the data connector in a different place such us under the hood near the left fender or close to the cowl on the right side. It can be hidden by a cover or a dead end connector.
What to look for in a Ford B1352 code?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the B1352 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city.
Where is the speed sensor on my car?
Repair as required. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly. If the wiring and connectors are OK, then check the voltage at the speed sensor.
What does DTC stand for on a speed sensor?
Technical Description. Vehicle Speed Sensor “A” Malfunction. This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles, including but not limited to Ford, Toyota, Dodge, BMW, Subaru, Honda, Lexus, Mazda, etc. Although generic, the specific repair steps may vary depending on make/model.
