What is lm311d?

What is lm311d?

Basically, the LM 311 IC is one kind of voltage comparator with high speed. This IC can also function with 5Volts for the logic systems. The output levels of the IC have the MOS logic or TTL, RTL, DTL compatibility level circuits. This IC can be used to drive Solenoids, Lamps, Relays, etc.

What is a LM311 comparator?

LM311 is a general-purpose integrated comparator with low open-loop gain, large offset voltage, and low common-mode rejection ratio; however, it has a fast response speed, short transmission delay time, and can directly input high-level signals to the microcontroller.

Which of the following is a feature of LM 311?

LM 311 is basically a voltage comparator having high speed. These features include fast response time, strobe capability, wide voltage supply ranges, maximum input current, operating at single 5V power supply ranges, low power consumption, large input differential voltages etc.

Whats a comparator do?

A comparator circuit compares two voltages and outputs either a 1 (the voltage at the plus side) or a 0 (the voltage at the negative side) to indicate which is larger. Comparators are often used, for example, to check whether an input has reached some predetermined value.

What is the use of LM339?

LM339 is used in applications where a comparison between two voltage signals is required. In addition with four of those comparators on board the device can compare four pairs of voltage signals at a time which comes in handy in some applications.

How many pins do 747 amplifier have?

14 pin
Pin Configuration of LM747 IC. The LM 747 IC is a 14 pin dual op-amp device. The pin configuration with the description for every pin in the op-amp1 as well as op-amp2 is explained below.

What is balance strobe?

The strobe pin allows you to turn off the output stage. The balance pin are for canceling the DC-offset voltage.

What circuits use comparators?

A comparator circuit compares two voltages and outputs either a 1 (the voltage at the plus side; VDD in the illustration) or a 0 (the voltage at the negative side) to indicate which is larger. Comparators are often used, for example, to check whether an input has reached some predetermined value.

What is the difference between op amp and comparator?

The difference between an op-amp comparator and a voltage comparator is in the output stage as a standard op-amp has an output stage that is optimized for linear operation, while the output stage of a voltage comparator is optimized for continuous saturated operation as it is always intended to be close to one supply …

How many comparators does 339 IC have?

Exercise :: Linear-Digital ICs – General Questions

What is lm in IC?

The LM series originated with integrated circuits made by National Semiconductor. The prefix LM stands for linear monolithic, referring to the analog components integrated onto a single piece of silicon.