What is DTC p0011 code for 2013 Chevy Equinox?

What is DTC p0011 code for 2013 Chevy Equinox?

Please try again later. 2013 Equinox with 2.4L Ecotech engine. Diagnosed with DTC P0011 code relating to intake camshaft actuator performance. Causes: Low oil, Dirty oil, chafted wiring to intake camshaft actuator, faulty intake camshaft actuator. Wiring looked good and oil changed recently, led to diagnose as bad actuator. Loading…

What does trouble code p0011 mean on a car?

The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be.

What causes the engine light to go off on a p0011 Chevy?

P0011 CHEVROLET Possible Causes. Low or Dirty Engine Oil. Faulty Intake Camshaft Position Actuator Solenoid. Intake Camshaft Position Actuator Solenoid harness is open or shorted. Intake Camshaft Position Actuator Solenoid circuit poor electrical connection.

What to do if your Chevy Equinox has a trouble code?

This is great for both power and fuel economy. If your Equinox has the P0011 trouble code it will typically not pass the State emissions tests. The Chevy Equinox utilizes camshaft actuators to change the valve lift depending on the RPM of the motor.

What does engine code p0011 mean?

A P0011 code refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car’s PCM (powertrain control module) or ECM (engine control module). VVT is a technology used in the engine to allow it to get greater power or efficiency at different running points.

What does code p0011 mean on an Impala?

P0011 is a very common trouble code. It affects vehicles with variable valve timing (VVT). The list of VVT vehicles is growing, and the Chevy Impala can have VVT, and is prone to developing this code. P0011: Camshaft Position “A” – Timing Over Advanced -or- System Performance (Bank 1) P0011 is a generic OBDII code.

What is a p0011 code?

P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”.