What is CMP sensor circuit?

The camshaft position sensor calculates the speed at which the engine’s camshaft rotates. It also keeps track of the shaft’s precise position during rotation. It signals the PCM, which uses the sensor data to set the timing for the ignition and fuel injection systems.

How do you test a CMP sensor?

Testing a Two-Wire Sensor:

If you have a two-wire, magnetic-type CMP sensor, set your multimeter to “AC volts.”
Have an assistant turn the ignition key on without starting the engine.
Check for the presence of power flowing through the circuit.
Have your assistant crank or start the engine.

What is the problem with the p0341 sensor?

P0341 – Camshaft position (CMP) sensor A, bank 1 range/performance problem Trouble Code Fault Location Probable Cause P0341 Camshaft position (CMP) sensor A, bank 1 Insecure sensor/rotor, air gap, wiring,

Is there a p0341 code on my Savana?

Have a 2007 chevy avalanche 5.3 lit with stored DTC,s P0016 & P0340.Pending P0340 and P0341 codes. MIL has been going on and of for months with no drivability problems have a innova 3130 scanner that … read more

What is the diagnostic code for Camshaft Position Sensor?

Cost of diagnosing the P0341 code P0341 is a diagnostic trouble code (DTC) for “Camshaft Position Sensor Circuit Range/Performance”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

How does the CMP sensor work on a Savana?

The CMP sensor produces a magnetic field whenever the ignition is ON. The CMP sensor is mounted near a reluctor wheel that is attached to the distributor shaft. When the distributor shaft rotates, or when the engine is cranking or running, the reluctor wheel changes the magnetic field.

What is the p0341 code for Camshaft Position Sensor?

P0341 code is triggered when the powertrain control module (PCM) detects a problem with the signal being sent by the camshaft position sensor. To learn more about how the ECM/PCM uses signals from the CMP, you can read our in-depth explanation here.

What does the p0341 OBD-II trouble code mean?

What the P0341 code means P0341 is an OBD-II generic code that says the engine control module (ECM) detected the engine camshaft position sensor circuit is not within specifications. The sensor pulses do not correlate to the pulses of the crankshaft sensor. What causes the P0341 code?