What is a compass data error?
What is a compass data error?
It just means that your car’s compass isn’t working correctly. The compass is either our of batteries (located in rearview mirror), the rearview mirror wasn’t installed correctly, or the compass needs re-calibration. The re-calibration technique should be explained in the owner’s manual.
Where is the electronic compass on a Ford F-150?
Ford F-150 trucks made after 2000 have an electronic compass that is located in a console above the rear view mirror, attached to the ceiling of the cabin. The compass has an LED display that is controlled by resistors on a circuit board. The resistors are soldered to the circuit board, but can become loose with time. …
How do you repair an overhead compass in a Ford Explorer?
Pulling down on the tab will begin to release the console from the ceiling. Slide your fingers into the gap until you are 3/4 of the way toward the front. Next, pull the console firmly to release the two tabs that secure it to the ceiling. 2001 Ford Explorer Sportrac Overhead Console.
How is the compass on a Ford truck calibrated?
The compass is calibrated as follows: Find an open area free from steel structures and high voltage power lines Ensure that all doors are closed and the map lamp in overhead console is off
How do you remove a compass from a truck?
The resistors are soldered to the circuit board, but can become loose with time. If your compass display is blank or intermittent, one or more of the resistors must be re-soldered to the circuit board. Turn off your truck and remove the compass console from the roof of the cabin.
Ford F-150 trucks made after 2000 have an electronic compass that is located in a console above the rear view mirror, attached to the ceiling of the cabin. The compass has an LED display that is controlled by resistors on a circuit board. The resistors are soldered to the circuit board, but can become loose with time.
Why do I need to calibrate my Ford compass?
It is intended for any Ford vehicle that has the compass display in the inside rearview mirror. Because the vehicle’s sheet metal magnetism tends to change over time, the compass may lose accuracy and need to be calibrated. This condition is indicated if the True North Adjustment does not correct an inaccurate compass.
How to use an electronic compass in a car?
Electronic compass (if equipped) 1 Start the vehicle. 2 To calibrate, press and hold the RESET control for approximately ten seconds until CAL appears. Release the control. 3 Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CAL display changes to the direction value. 4 The compass is now calibrated.
The resistors are soldered to the circuit board, but can become loose with time. If your compass display is blank or intermittent, one or more of the resistors must be re-soldered to the circuit board. Turn off your truck and remove the compass console from the roof of the cabin.
