What happens to the brakes in a Chevy Camaro?
What happens to the brakes in a Chevy Camaro?
If the rear circuit fails (i.e., rear brakes lose pressure from a ruptured brake line), the pressure on both sides of the piston is no longer equal, causing the greater pressure on the front brake circuit to push the switch actuator piston inside the distribution block to an off-center position (toward the rear in this example).
Where is the brake warning switch on a Chevy Camaro?
The rear brake line is a single line coming from the rear circuit of the master cylinder. It comes back out of the distribution block as a single brake line to the rear brakes. The brake warning switch is located in the middle of the distribution block.
Where is the brake distribution block on a Camaro?
The first-generation Camaro factory brake distribution block has front and rear brake lines going into and out of it, as well as a single wire for the brake warning switch. The distribution block is located about 1 inch under the master cylinder and mounted to an L-shaped bracket that’s attached to the right-front master-cylinder mounting stud.
What are the brake wires on a 1967 Chevy Camaro?
The bail wires (straps) on the master cylinder are bare steel or silver if you want to paint them and the top cover is gold-cadium plated. This 1967 manual brake master cylinder is original and is supposed to be finished the same way as the power-assist unit.
Are there front disc brakes on a Camaro Z28?
While SS neither included nor required front disc brakes, the J50/J52 combination was a mandatory option for Z28. The disc calipers were a 4-piston design used only in 67 and 68. – The RPO J65 metallic drum brake option added metallic brake shoes on all 4 drums.
If the rear circuit fails (i.e., rear brakes lose pressure from a ruptured brake line), the pressure on both sides of the piston is no longer equal, causing the greater pressure on the front brake circuit to push the switch actuator piston inside the distribution block to an off-center position (toward the rear in this example).
The rear brake line is a single line coming from the rear circuit of the master cylinder. It comes back out of the distribution block as a single brake line to the rear brakes. The brake warning switch is located in the middle of the distribution block.
What kind of brakes did a 1967 Camaro have?
1967 included two one-year-only brake options: – The RPO J65 metallic drum brake option added metallic brake shoes on all 4 drums. J65 was supposedly only available on 67 SS’s but it has been observed on a few non-SS cars.
