What does code U010C mean?
What does code U010C mean?
Lost Communication with Turbocharger/Supercharger Control Module
Code U010C stands for Lost Communication with Turbocharger/Supercharger Control Module. A regular engine is restricted to the amount of air the pistons can draw in. But, the more air that can be forced into an engine (along with the corresponding amount of fuel), the more power it will make.
Why is my u010c code not working?
If you can access codes from the TSCM-A, then the U010C code is either intermittent or a memory code. If unable to access the TSCM-A, then the U010C code that the other modules are setting is active, and the problem is there now.
What does ” lost communication with turbocharger ” mean?
This is a generic communication system diagnostic trouble code that applies to most OBD-II vehicle makes and models. This code means that the Turbocharger / Supercharger Control Module A (TSCM-A) and other control modules on the vehicle are not communicating with each other.
Why is my Ram 3500 setting code u010c?
This is the electronic turbo actuator on your model that is causing the code to set. The engine computer is not able to communicate with it. The PCM ( engine computer ) sends the voltage signals to the turbo actuator so it doesn’t have its own fuse, unfortunately. The most common cause is the turbo actuator itself at fault.
What causes a turbocharger control module to fail?
The most common failure is a circuit fault which causes the loss of power or ground to the turbocharger / supercharger control module a. Check all fuses that power up the TSCM-A module on this vehicle.
Why do I keep getting trouble code u010c?
I keep getting a u010c trouble code saying “I’ve lost communication w/ the turbo/super charger control module. I had this pop up right after i done my last oil change about 2 months ago; been clearing the DTC out w/ my Ultra, but it comes back on in a few days or so.
What does it mean when your turbocharger says u010c?
Code U010C indicates the turbocharger/supercharger is not receiving or transmitting messages on the CAN bus. Code U010C is typically caused by one of the following: Sometimes U010C can pop up intermittently, or it can result from a dead battery.
This is a generic communication system diagnostic trouble code that applies to most OBD-II vehicle makes and models. This code means that the Turbocharger / Supercharger Control Module A (TSCM-A) and other control modules on the vehicle are not communicating with each other.
What does the code u0100 stand for?
Sometimes it be reprogrammed rather replaced. All the ‘U’ codes are network communication codes. Codes U0100 to U0300 are lost communication with XX module codes. This code is typically monitored when the ignition is on and battery voltage is within a specific range.
