What does code P229F mean?
What does code P229F mean?
NOx sensor
What does the Mercedes Benz P2202 P229e P229F error codes mean? This is a generic code to signify the electronic control module of your vehicle has detected that the sensor signal of your NOx sensor is low on bank one. It is caused by the ECM receiving lower than expected voltage from the signal wire.
When to use the p2201 NoX sensor code?
The P2201 code is set when the ECM detects an out of range electrical condition within the bank #1 NOx sensor or circuit. Note: On engines with more than one bank of cylinders (e.g. V6, V8), bank 1 is the side of the engine that contains the #1 cylinder.
What does the Diagnostic Code p2201 stand for?
The P2201 diagnostic trouble code indicates that the nitrogen oxide (NOx) sensor circuit is out of range or has a performance issue. The purpose of the NOx sensor is to measure the amount of nitric oxide and nitrogen oxide in the exhaust system, and when the storage capacity of these harmful gases has been reached.
Where is the p2201 code located on the ECM?
The P2201 code is set when the ECM detects an out of range electrical condition within the bank #1 NOx sensor or circuit. Note: On engines with more than one bank of cylinders (e.g. V6, V8), bank 1 is the side of the engine that contains the #1 cylinder. Therefore, the NOx sensor is located in the exhaust of that bank.
Which is diagnostic trouble code for NoX sensor circuit range?
P2201 is a diagnostic trouble code (DTC) for “NOx Sensor Circuit Range/Performance Bank 1”.
The P2201 code is set when the ECM detects an out of range electrical condition within the bank #1 NOx sensor or circuit. Note: On engines with more than one bank of cylinders (e.g. V6, V8), bank 1 is the side of the engine that contains the #1 cylinder.
The P2201 diagnostic trouble code indicates that the nitrogen oxide (NOx) sensor circuit is out of range or has a performance issue. The purpose of the NOx sensor is to measure the amount of nitric oxide and nitrogen oxide in the exhaust system, and when the storage capacity of these harmful gases has been reached.
The P2201 code is set when the ECM detects an out of range electrical condition within the bank #1 NOx sensor or circuit. Note: On engines with more than one bank of cylinders (e.g. V6, V8), bank 1 is the side of the engine that contains the #1 cylinder. Therefore, the NOx sensor is located in the exhaust of that bank.
P2201 is a diagnostic trouble code (DTC) for “NOx Sensor Circuit Range/Performance Bank 1”.
