What does a Turbo 400 transmission look like?
What does a Turbo 400 transmission look like?
The TH-400 uses an oblong-shaped pan with one side having a “hump” in the pan and one side is curved while the other two sides are straight. The TH-400 pan also has two circular indentations on the humped side of the pan. Measure the transmission.
What was the horsepower of a 1978 Pontiac Trans Am?
Basic specs for the 403 engine include a 4.35 x 3.38-inch bore and stroke, 8.0:1 compression ratio, five mains, hydraulic lifters and a four-barrel carburetor. Horsepower came in at 185 and torque was 320-lbs.ft., measured at the flywheel.
What are the specs for a Turbo 400 transmission?
Turbo 400 Performance Specs The Turbo 400 is rated conservatively at peak torque of 450 lb-ft. That being said, this transmission is commonly used in hot rods and paired with engines making far more torque, although these transmission also must commonly updated with some aftermarket parts.
How to make a’79 olds 403-powered Trans?
Here’s one by nrd515 describing how he got a 403 Olds-powered ’79 TA to run 13.35/105 in the quarter mile. If nothing else, it proves that the 403 can be made to fly) I knew someone who got an ’81 Turbo T/A from their parents as a HS graduation present. It was disappointing, to put it mildly.
Can You rebuild a Firebird Pontiac Trans Am?
Firebirds and Trans Ams fitted with the special high-performance engines command the highest values, but certainly the more common Firebird and Trans Am V-8 cars are worth rebuilding. This Tech Tip is From the Full Book, TRANS AM & FIREBIRD RESTORATION: 1970-1/2 – 1981.
What kind of transmission was in a 1978 Pontiac Trans Am?
TRANSMISSIONS Unlike the days of old when you could select from an assortment of transmissions, the 1978 T/A was built with only two variants. The Turbo Hydra-Matic 350 automatic, as seen in Blattner’s T/A, was standard equipment, coded as M33. This very common three-speed trans was mated with all three available engines.
Turbo 400 Performance Specs The Turbo 400 is rated conservatively at peak torque of 450 lb-ft. That being said, this transmission is commonly used in hot rods and paired with engines making far more torque, although these transmission also must commonly updated with some aftermarket parts.
Here’s one by nrd515 describing how he got a 403 Olds-powered ’79 TA to run 13.35/105 in the quarter mile. If nothing else, it proves that the 403 can be made to fly) I knew someone who got an ’81 Turbo T/A from their parents as a HS graduation present. It was disappointing, to put it mildly.
When did the General Motors Turbo 400 come out?
The TH400, or Turbo 400, transmission was a 3 speed automatic that was first produced in 1964. This transmission became well-known for its strength and was very popular, based on its life and the number of applications in which it was installed. It was not only used in General Motors applications, but was also used for many luxury cars.
