What does a stub axle do?
What does a stub axle do?
What is the function of stub axle? The stub axle or stud axle is either one of the two front axles in the rear wheel drive vehicle, or one of the two rear axles in the front wheel drive vehicle. In a rear wheel drive vehicle this axle is capable of angular movement about the kingpin for steering the vehicle.
What to do with an old stub axle?
Remove old stub axle . Install new axle and tighten with supplied grade 8 nyloc nut. Slide inner bearing on to axle. If it’s new, pack it with grease. If it’s old, I’d leave the old grease in it for now and re-pack it later. DO NOT use the felt oil seal yet. Slide spacer on to the axle.
How to tighten stub axles on 1975 TR6?
Make sure there’s no grease between the bearing and the edge of the spacer at both ends of spacer. Put the hub on to the axle and up against the inner bearing. Slide a shim (start with .007) on to the axle. Put the outer bearing on to the axle and in to the hub. Install the “D” washer, castle nut and tighten to 50 pounds
Do you put felt oil seal on stub axles?
DO NOT use the felt oil seal yet. Slide spacer on to the axle. Make sure there’s no grease between the bearing and the edge of the spacer at both ends of spacer. Put the hub on to the axle and up against the inner bearing. Slide a shim (start with .007) on to the axle. Put the outer bearing on to the axle and in to the hub.
Who is the owner of Uncle Jack’s stub axles?
Uncle Jack’s Stub Axles Jack Drews and his son Tony have been racing Triumphs for quite some time and, as a result, have come up a number of improvements to stock parts that have a tendency to break or under-perform during race conditions.
Remove old stub axle . Install new axle and tighten with supplied grade 8 nyloc nut. Slide inner bearing on to axle. If it’s new, pack it with grease. If it’s old, I’d leave the old grease in it for now and re-pack it later. DO NOT use the felt oil seal yet. Slide spacer on to the axle.
Make sure there’s no grease between the bearing and the edge of the spacer at both ends of spacer. Put the hub on to the axle and up against the inner bearing. Slide a shim (start with .007) on to the axle. Put the outer bearing on to the axle and in to the hub. Install the “D” washer, castle nut and tighten to 50 pounds
DO NOT use the felt oil seal yet. Slide spacer on to the axle. Make sure there’s no grease between the bearing and the edge of the spacer at both ends of spacer. Put the hub on to the axle and up against the inner bearing. Slide a shim (start with .007) on to the axle. Put the outer bearing on to the axle and in to the hub.
What to do if your CX axle shaft is stuck?
CX AXLE SHAFT STUCK – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
