What causes turbo seal failure?
What causes turbo seal failure?
Oil leaks can be caused by a variety of factors, the main factor being incorrect pressure within the compressor and turbine housings. Oil leaks can cause catastrophic damage to the bearing systems and occur within seconds of the turbocharger commencing operation.
What is the adapter for fuel injector return?
Use adapter CH-50378 (required to accurately test return, contains regulator to maintain injector return pressure) to route the injector return into a graduated container. Crank or idle the engine until fuel is dripping out of the line.
Where is the fuel injector located in the fuel rail?
At the top O-ring where the fuel injector is located in the fuel rail. (Repairable – replace O-ring) The fuel Injector pintle, ball or disc seat due to damage or corrosion (Not repairable, Discard Injector) The fuel injector body at the top of the fuel injector. (Not repairable – Discard fuel Injector) Test leaking Fuel Injectors.
What happens if the fuel injector is not working?
Fuel injectors are a vital part of a complex fuel management system. Furthermore, New technology has made fuel injectors more precise than ever in dispensing fuel. If the fuel injectors are not operating properly, then other parts of the engine will be affected as well.
What to do if fuel leaks from injector?
Plug the fuel return line fitting with a suitable tool (CH-50377-A). Crank the engine for 15 seconds and verify no fuel leaks from the injector. If fuel leaks from the injector, replace it. Repeat for all eight injectors.
Can a fuel injector last the life of the engine?
In general, fuel injectors are hard wearing and with a little care, can often last; the life of the engine. Like any other engine part, regular maintenance is the key, to keeping them going.
What causes a fuel injector to stop working?
Over time the nozzle of the injector can become dirty and partially blocked. When you shut off your engine the injector will, soak up the heat of the engine. This causes any fuel left in the injector to evaporate, leaving behind hard deposits, inside the injector. Over time, these will eventually block the injector.
What causes wear and tear on fuel injectors?
Driving a car hard, combined with short start stop journeys, will increase the wear and tear on injectors. Letting the engine cool down, before shutting it off, will increase the lifespan of the injectors. This will also, benefit the rest of the engine too.
When to replace fuel injector seals and washers?
If the O-ring fitted to the injector is the problem; then replacing this O-ring will usually fix the leak. If the injector body; nozzle or internal components are cracked; then a new or refurbished injector is your only option. Replacement fuel injector seals and washers are cheap and are, fairly easy to install.
