What causes the p0206 OBD-II trouble code?

When a P0206 code is seen, the Engine Control Module (ECM) has detected either voltage or resistance that is out of specification in the fuel injector circuit for cylinder 6. What causes the P0206 code? What are the symptoms of the P0206 code?

What does PCM p0206 mean on an injector?

Although generic, the specific repair steps may vary depending on make/model. P0206 means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled “low” or close to zero.

What to do if your injector code is p2149?

If the vehicle had only injector circuit codes for P0202 or P0207 (with bank shutdown P2146 or P2149), and the wiggle test induces a P0202 or P0207 to reset, use bulletin number 05-06-04-047B to repair the injector connectors and install the injector harness support kit.

Which is the most common cause of p0206?

Installs a noid light between the fuel injector cylinder 6 and the wiring harness to test pulse width The fuel injector is the most common cause of P0206, especially on higher mileage vehicles. The fuel injector must be fully tested and all steps performed, otherwise incorrect repairs may be made.

What causes a p2149 fuel injector supply voltage code?

Causes for this P2149 fuel injector group supply voltage code may include: Defective or damaged fuel injector (s)

What are the codes on my 06 Ram Cummins?

My 06 ram cummins threw these code while pulling camper and decilerated and idled roughley untill I turned engine off and restarted it then it ran fine. The codes are P0238, P0237, P2149, and P0513. I reset the the codes with my edge attitude chip and they never returned, but I would like to know w…

What to do if you get trouble code p2149?

If the trouble codes or customer concern is induced during the wiggle test on any other cylinders (other then P0202/P0207), replace the affected injector connector pigtail with P/N 88988963. This replacement pigtail can be used to repair any cylinder except number 2 and number 7.

What is the fault code for a Dodge Ram 2500?

2003 dodge Ram 2500 Cummins, need help troubleshooting fault codes P0204 and P2149. Engine runs rough, no power. Code P0204 says “Injector circuit malfunction cylinder 4″ and code P2149 says”Fuel injector grp B supply voltage circuit open” I’m thinking problem could be a faulty injector or inject…

What does p0208 mean on a cylinder 8 injector?

Although generic, the specific repair steps may vary depending on make/model. P0208 means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled “low” or close to zero.

What does the p0206 code on the ECM mean?

What the P0206 code means. When a P0206 code is seen, the Engine Control Module (ECM) has detected either voltage or resistance that is out of specification in the fuel injector circuit for cylinder 6.

What causes the p0208 OBD-II trouble code?

All our repairs are backed by our 12-month / 12,000-mile warranty. P0208 is set when the Engine Control Module (ECM) detects voltage or resistance that is out of range in the cylinder 8 fuel injector circuit. This code is similar to codes P0200 – P0207, and P0209 – P0212, which all indicate fuel injector circuit issues. What causes the P0208 code?

What causes a p0206 engine light code to appear?

The causes of a P0206 engine light code could be any of the following: Bad injector. Open in the wiring to the injector Short in the wiring to the injector Bad PCM

What does p0208 mean on a PCM?

P0208 means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled “low” or close to zero.

What are the OBD codes on a 2002 Jeep Grand Cherokee?

I recently did an OBD Test on my 2002 Jeep Grand Cherokee 4.7L V8 it gave me 3 codes P0206, P0121 and P0455 I was wanting to know the meaning of these codes Thank you… Having codes come up: P0203, Po206, P0208, P0306, P0308, P0300, P0303 I’m having trouble and would like help from anyone knowlegable about these codes.

What’s the diagnostic code for injector circuit malfunction?

P0206 is a diagnostic trouble code (DTC) for “Injector Circuit Malfunction – Cylinder 6”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation. Our certified mobile mechanics can come to your home or office to perform the Check Engine Light diagnostic for $0.0 .

What is the diagnostic code for cylinder 6?

P0206 is a diagnostic trouble code (DTC) for “Injector Circuit Malfunction – Cylinder 6”.

What causes the p0206 OBD-II trouble code?