What causes a Yamaha Venturer to backfire?
What causes a Yamaha Venturer to backfire?
Many Venturer members have installed their passing lights differently from how the Yamaha Passing Light instructions say to …… Adjusting the Pilot CircuitContributed by Dan Abbott The backfire is caused by too lean a setting of the pilot circuit. This causes hotter exhaust gas temps. which ignite any unburned mixture ……
Is the trailer light on a Yamaha Venture mechanical?
Trailer Light Wiring Contributed by Norms99 Generally, a motorcycle with self cancelling signals and four way flashers, like the Venture, are not mechanical. Therefore, they will not work properly when ……
How to troubleshoot a daytime running lights problem?
Use a Phillips screwdriver to remove the light assembly. Place all of the screws in a safe place so that none of them are lost. Tug on the electrical connector at the rear of the assembly. If the connector comes out or is loose, plug it securely into the rear of the assembly.
Where is the alternator on a Yamaha Venture?
The RSV charging system uses a permanent magnet type AC Magneto (ACM) alternator. The stator and rotor of the alternator are located inside the left engine cover. The rotor is attached to …… I had to split my fairing this morning to chase a short in my passing lamp wiring, which I did find and fixed.
Are there rear running lights on a V-twin?
No rear running lights! Can’t figure it out. Brake light works, rear turns work, but no rear running lights. Fuses have continuity and wires look good. The brake bulb was blown and I replaced it, so I’m thinking maybe I had a surge.
Are there any running lights at the back of the car?
Think about a car…. red running lights in the rear, turns can be amber or red. The kits change bulbs also, to double element, which provides ‘run’ and brake function, and is required to be RED. Running lights at rear should be RED. It might in fact be the law ( I have heard this ). Just my 2 cents, trying to help, that’s all.
How to troubleshoot and repair automotive running light problems?
Step by step guide on how to troubleshoot and repair automotive tail and running lights, this information pertains to not working, dim and flickering lighting systems. Begin with the car on level ground, engine off with the parking brake set, wear protective gloves and eye wear.
Why are rear lights not working but brake lights are?
If the rear light lights up correctly but does not become bright when the brake is applied then the switch of the brake is faulty. This circuit is connected with the brake pedal – if the switch is out of place or connected incorrectly then the pedal may not be able to complete the circuit correctly.
