What causes a Chevy 2500HD to lose power under load?
What causes a Chevy 2500HD to lose power under load?
Probably P0087. Check the fuel hoses at the side of the trans– they can get kinked, weak and collapse. I’ve just experienced a very similar situation with my 2005 2500HD. After driving about 2 hours, over varying terrain, I had to stop at a light (not the first on the trip).
What happens when a Duramax engine goes down?
Not only does this mean game-over for the engine, but it results in a truck that’s down for weeks (if not months) and a huge chunk of change missing from your wallet. The failure is most common in higher horsepower engines, but can still occur in moderately modified and even stock power plants.
Are there any problems with the LLY Duramax?
In terms of LLY injector problems, GM had sorted out the internal failures with the 2004 ½ redesign, but the LLY Duramax would occasionally exhibit a trouble code for the injectors, but in most cases it turned out to be an issue with the injector harness rubbing through and causing a short or open in the wiring.
What causes a Duramax injection pump to fail?
As a result (allegedly), the lack of lubrication in the fuel can cause a premature failure of the injection pump, to a point where it won’t allow the LML Duramax to run. You can be driving down the road and everything seems normal, and when the pump fails, the truck just shuts off.
Probably P0087. Check the fuel hoses at the side of the trans– they can get kinked, weak and collapse. I’ve just experienced a very similar situation with my 2005 2500HD. After driving about 2 hours, over varying terrain, I had to stop at a light (not the first on the trip).
When does a Duramax chev.p.u.lose power?
Duramax Chev. P.U. (2003) loses fuel prime and motor stops running at low RPM or at an idle. No visible leak around filter area. Fuel pressure … read more Vocational, Technical or Tra… Hi, I just purchased a 2004 Kodiak C4500 crewcab with the Duramax diesel engine mated to an Allison with 4:44 gear ratio. What rpm do you … read more
Are there any problems with the Duramax LMM?
One problem can rear its head when you are pushing the power of the LMM to a level GM never imagined, and that’s with the pistons. Simply put, they can crack under pressure. There are a lot of factors which dictate the power level where a piston bites the dust, but it’s usually north of 600 horsepower.
Why is my Duramax diesel engine not working?
The trucks computer keeps track of how much fuel needs to be added or subtracted from each individual cylinder to make the engine run smoothly, and this value is called the balance rate. If one cylinder is contributing too much or not as much as the rest, the cause is usually a bad injector and the cure is a replacement.
What causes a GMC Sierra engine to misfire?
Keeping in mind that any engine needs air, fuel, and spark for ignition, your GMC Sierra’s fuel system can often cause the engine to misfire. It can run too lean or rich. Alternatively, there may not be enough fuel for proper combustion, or the fuel isn’t atomizing properly.
What causes a GMC Sierra to run rough?
EGR- The EGR system recycles burnt exhaust gasses back into the combustion chamber. Crank/Cam Sensor- When the cam or crank sensors are not being read by the ECM/PCM, it’s impossible to get the ignition timing right. If you Sierra does start at all, it’ll run rough.
What causes a flashing check engine light on a GMC Sierra?
While a majority of the time, the flashing check engine light is going to be caused by a misfire related to your Sierra’s ignition system or fuel system (as stated above), there are other issues that can cause it. Your timing chain could have jumped .
