What are the specifications of a caterpillar 277c?

Caterpillar 277C Specifications & Technical Data (2007-2015) Rate this machine now! Weight: 4.25t – Rated operating capacity: 1451kg – Track width: 457mm – Bucket capacity: 0.48m³ – Driver protection: Ü – Transport length: 3.692m

Can a skid steer go forward or backward?

Skid steer..The lift arms and bucket hydraulics will not operate… I have a CAT 277… I have a CAT 277 track skid steer. It will travel forward and backward. The lift arms and bucket hydraulics will not operate. The door has been removed and the wires spliced for the safety switch. There is no pump noise when operating the controls.

What to do if your skid steer does not work?

If you have auxiliary hydraulics check the jumper wire on the quick coupler connector mounted on the left loader arm. The Interlock ECM will NOT engage the work tool pilot solenoid if problems exist with the parking brake switch or the work tool pilot solenoid.

What should the voltage be on a skid steer?

CHECK THE BATTERY VOLTAGE Start the engine and run at high idle for several minutes. Measure the battery voltage at the battery posts. The voltage should be greater than 12 DCV. OK – The voltage is greater than 12 DCV. Proceed to Test Step 1.

How old is my cat 277c track loader?

Discussion in ‘ Track Loaders ‘ started by uzz32soarer, Jan 27, 2016 . Hi Guys, I’m a newbie here from the other side of the World but I’m having an issue that needs some outside expertise. I have a 277C with only 200 hours on it, but it is three or four years old.

How to turn off the light and beeper on Cat 277c?

At first the light and beeper came up and stayed on until forward motion stopped and hand was off joystick. Then after a while it actually stopped the machine, no forward or backward motion just the bucket still operating fine. Turn off the machine and do a full restart and it came back again.

Where is the cable on a cat 277c?

The right side cable was beautifully placed in a cleft created by the two hydraulic lines. Well protected and laid. Left side was a mess. Wrapped around hydraulics, more exposed, clearly no care placing that when the machine was wired.

What are the specifications of a caterpillar 277c?