Other

What are the parts of a Ferguson TO20?

What are the parts of a Ferguson TO20?

Alternator Top Bracket – Adjustable top bracket used in 12 volt conversion kit. For model TO20. Hardware kit available as part number HDW9302. (Part No: GFD9314) Battery Cable – Cable, starter switch to starter. Tractors: TO20, TO30. 15 inches long. (Part No: 180099M91) Battery Cable – Cable, battery to switch.

When was the Ferguson to 20 tractor built?

The Ferguson TO-20 was built from 1948 through 1951. The lift has draft control only (for plowing), so it will always behave a little funky. If you put your body weight on the lift arms, they should go down. Below is an explanation extracted from the internet explaining why Harry Ferguson built them this way:

What are the parts numbers for a Ferguson tractor?

Control Box, 12 Volt – Control box is for tractors with a generator and Standard Motor gas engines. Replaces OEM numbers: 829951M91, 1050840M91. For tractor models 20E, 240, 275UK, 283UK, 290UK and TE20, TEA20, TO20, TO30, TO35.

How do you set points on a Ferguson tractor?

Park the Ferguson TE20 on a flat surface and turn the engine off with the transmission in gear. Place the wheel chocks in front of each rear wheel and behind each rear wheel. Move the gear shifter to the neutral position. Unsnap the hold-down clamps on the side of the distributor cap. Pull the distributor cap off and place it on the tractor seat.

Is the Ferguson to-20 the same as the Ford TE-20?

The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement went bad in an attempt to take away Ford’s market for the N-Series tractors.

Where can I get parts for my Ferguson TO20 tractor?

Our experienced and friendly sales staff are available to help with any of your Ferguson TO20 tractor parts and engine parts needs. Call our toll-free customer support line today if you have any questions. 1-800-853-2651, available Monday – Friday, 7:00-3:30pm (PST) 9:00-5:30pm (CST) 10:00-6:30pm (EST).

Why did Harry Ferguson build a to-20 tractor?

Below is an explanation extracted from the internet explaining why Harry Ferguson built them this way: “Quadramatic Control.” TO-30 and earlier models [TO-20] do not have built in position control.

How does the distributor work on a Ferguson TE20?

The electrical points are opened and closed by the lobe on the distributor shaft; each time the lobe contacts the points, the points open and close. To time the points to the ignition coil, you adjust the gap between the points. Park the Ferguson TE20 on a flat surface and turn the engine off with the transmission in gear.

Author Image
Ruth Doyle