What are the main ground wires on a Chevy Malibu?

I Have a 300 RMS sub and two 50 RMS 6×9’s, and it can make my lights dim. The biggest user of electricity on the car (before mods) is the starter. The battery has a heavy cable from the negative terminal to the engine block, then another smaller wire (still big, tho) from the battery to the car’s chassis.

Which is the fusible link for Chevy Malibu starter?

For future reference compatible fusible links are Dorman 85620 or NAPA 784696. Not open for further replies. Did you find the recommended reading relevant to this discussion? Help us improve your recommendations by telling us what you would like to see.

Where does the wiring go from the battery to the starter?

3) If you look at the wiring leaving the positive terminal from the battery, there is one cable that goes down to the starter and another one that goes over to the under hood fuse box. If you remove the cover from the fuse box, you will see where that cable is screwed into the box.

What causes a car starter to not start?

Most starter problems occur in predictable places, and diagnostics are easy to run. When your car fails to start, it could be because of a damaged starter component. It can also be a poor electrical connection or insufficient power. It starts the internal combustion of your engine.

How can I tell if my starter relay is bad?

Open bonnet and locate starter relay. On the started relay jumper the brown wire on terminal C1 to the white/brown wire on terminal C2, the starter should run. If not, you have a bad solenoid, or bad connection from relay down to the solenoid coil. If you hear the starter solenoid click then you could have a bad starter.

Where is the ground connection on a Chevy?

The BCM is located under the dash behind the passenger-side kick-panel. The “ground” connection is to the negative terminal of the battery… located forward of the BCM, under the hood. So you run a “ground” wire from the BCM back, toward the rear of the vehicle to terminate it to a bolt.. in the floor.

Where are the ground wires on a car?

The biggest user of electricity on the car (before mods) is the starter. The battery has a heavy cable from the negative terminal to the engine block, then another smaller wire (still big, tho) from the battery to the car’s chassis. There should also be at least one grounding strap from the engine to the chassis.

How are ground wires plugged into a splice pack?

You can’t see the individual ground wires that plug into it in that view, the body of the Splice-Pack blocks the view of the wires. The Splice-Pack is a simple piece of comb-shaped stamped steel with a plastic cover over it. It has a mounting-hole through which a screw secures it to the fender, which makes the “ground” connection.

How to disarm a Chevy Malibu Lt Green?

LT. GREEN (-) DISARMS WITH A (-) THRU A 500 OHM RESISTOR NOTE #1: This Vehicle Requires a Special INTERFACE BYPASS MODULE for the MULTIPLEX Ignition System and Anti-theft System this also includes the Keyless Entry System, part # DB-ALL or XK09, either will work, to order please go to the INTERFACE BYPASS MODULE Page on this website.

What causes electrical issues on a Chevy Malibu?

Poor Terminal Contact at BCM Connectors May Cause Electrical Issues on Chevrolet Malibu. Problem Description. Various electrical issues may be caused by poor terminal contact at the body control module (BCM) electrical connectors.

Where are the spark plugs on a Chevy Malibu?

PART COLOR LOCATION 12 VOLT CONSTANT RED/BLACK (+) @ BCM, RED 41-PIN PLUG (X3), PIN D1, SEE STARTER SEE NOTE #1 STARTER 2 N/A IGNITION 1 PINK (+) @ IGNITION SWITCH HARNESS, GREEN 6-PIN P