Other

Is there a transmission relearn for the new 545RFE?

Is there a transmission relearn for the new 545RFE?

Transmission relearn for new 545rfe?? Discussion in ‘ Engine & Performance ‘ started by lchron36, Oct 22, 2018 . Does anyone know how to do a transmission relearn or quick learn for the 545rfe?

When did the 68RFE RFE transmission come out?

The 68RFE was introduced in 2007 Ram 2500 and 3500 Pickups with the 6.7L Cummins ISB Diesel engine. The basic design and operation is the same or similar to the 45 and 545RFE counterparts with the following exceptions: Reverse 4.44:1

Where does the Chrysler RFE transmission come from?

The 45RFE was produced at the Indiana Transmission plant in Kokomo, Indiana. It was normally paired with the 4.7 L PowerTech V8 . The 45RFE later became the 5-speed 545RFE . 2nd Prime 1.50:1 Reverse 3.00:1 The 68RFE was introduced in 2007 Ram 2500 and 3500 Pickups with the 6.7L Cummins ISB Diesel engine.

What kind of transmission does Dodge Ram have?

I am replacing my transmission this weekend in my 2010 ram 2500 5.7 since the stock is shot. The trans I got is a re-manufactured transmission by Street Smart Transmission.

Transmission relearn for new 545rfe?? Discussion in ‘ Engine & Performance ‘ started by lchron36, Oct 22, 2018 . Does anyone know how to do a transmission relearn or quick learn for the 545rfe?

I am replacing my transmission this weekend in my 2010 ram 2500 5.7 since the stock is shot. The trans I got is a re-manufactured transmission by Street Smart Transmission.

Is there a warranty on a Dodge 545RFE?

Comes with a 3 year unlimited mile warranty, with torque converter and all of the fluid. And, the warranty covers self installs too which is great. Any other tips or tricks for install or removal of the 545rfe that I should be aware of?

Can a transmission be shifted to a new transmission?

The only potential issue is that the PCM is going to shift your new transmission based on the values of the old transmission. Which obviously those values won’t match up with a new transmission. Tolerances will be tighter and fill volumes won’t be the same.

What causes a Dodge Ram transmission to not shift?

Solution 1. Turn control switch to ON position. Cause 2. Overdrive Circuit Fuse Blown. Solution 2. Replace fuse. Determine why fuse failed and repair as necessary (i.e., shorts or grounds in circuit). Cause 3. O/D Switch Wire Shorted/Open Cut.

The only potential issue is that the PCM is going to shift your new transmission based on the values of the old transmission. Which obviously those values won’t match up with a new transmission. Tolerances will be tighter and fill volumes won’t be the same.

What makes a Dodge Ram 1500 not move?

The shift cable is fine, the transmission fluid is good. It’s throwing codes P0700 and P0841. I found a transmission service bulletin (TSB 21-007-06) that says a bad transmission cooler return filter and transmission sump filter can throw those codes, but would that also make my truck just sit there?

Is there a transmission issue in my Dodge Ram?

I have roughly 187K miles on it and had the tranny fluids R&R with both filters about 28K miles ago and it had been working fine, up until yesterday. No leaks or trans fluid droppings anywhere on the floor. I did start it up this morning and took it around the block and it seemed ok in “Drive” but parked it and used my work vehicle.

What to do if your Dodge Ram won’t shift into overdrive?

Having the light come on does not necessarily indicate whether the overdrive is indeed functioning as it should, but it is a good first step. You may try turning the overdrive function on and off to try and get the light to function properly. Put the Dodge Ram into drive and drive forward slowly at first, accelerating as you move.

What kind of car won’t shift out of second gear?

If you own a Chrysler vehicle and it won’t shift out of second gear, read this post. If you own a Chrysler, Dodge, or Plymouth vehicle and discover that the transmission will shift from first to second gear but will not shift out of second gear, your vehicle has locked itself into “limp-in” mode.

Can a hot engine cause a transmission issue?

Engine has to be hot as well as the transmission it tells you on the dipstick check hot and the engine needs to be hot too not running for a few short minutes.You are not going to get a accurate reading. Ended up taking it to a local trans shop this morning. The truck was shifting just fine this morning.

What should I use to rebuild my 45RFE transmission?

Platinum Lubegard – Insider tip: Many shops use this synthetic supplement in every freshly rebuilt transmission to keep them on the road past the warranty. Remember to soak all of your clutches in transmission fluid for thirty minutes before you install them.

Author Image
Ruth Doyle