Other

Is there a spark on my 1998 Sonoma?

Is there a spark on my 1998 Sonoma?

Put new coil on with again no spark. Checked out this forum and went out wiggled white wire with black stripe and whoooom started right up. Bad connection right at the plug in on coil. About to go out and fix this thing. Only 202,000 miles on tis 1998 sonoma 4×4, just keeps going! Thanks for the tip!!!!!! 20 people found this helpful.

Is the fuel pump on my 93 S10 working?

Yes got a 93 S10 I was driving down the street it stopped working I put a new fuel pump in it and you feel filter and still no start is there anybody out there that can help me 13 people found this helpful.

What was cause of 1998 Chevy S10 no spark?

9 people found this helpful. Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem.

Put new coil on with again no spark. Checked out this forum and went out wiggled white wire with black stripe and whoooom started right up. Bad connection right at the plug in on coil. About to go out and fix this thing. Only 202,000 miles on tis 1998 sonoma 4×4, just keeps going! Thanks for the tip!!!!!! 20 people found this helpful.

Yes got a 93 S10 I was driving down the street it stopped working I put a new fuel pump in it and you feel filter and still no start is there anybody out there that can help me 13 people found this helpful.

9 people found this helpful. Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem.

Why does my GM 4.3L engine not start?

No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.

Do you need a spark plug for a Chevy S10?

NOTE When performing the following tests, the vehicle’s battery must be fully charged. WARNING Never crank the engine or turn the ignition switch on with a high-tension spark plug wire or ignition coil wire disconnected.

Can a spark plug be disconnected from the ignition?

WARNING Never crank the engine or turn the ignition switch on with a high-tension spark plug wire or ignition coil wire disconnected. If a plug wire or ignition coil wire is disconnected, it should be grounded before the ignition is switched on or the engine cranked.

Why is my TBI fuel injection light on?

Troubleshooting your TBI Fuel Injection System Most of the problems encountered while installing your fuel injection system or after a time of operation are very simple. If your check engine light is on you more than likely have a hard fault meaning something is grounded out, unplugged, operating out of range or has gone bad.

How to troubleshoot a no start GM 4.3L pick up?

Testing a Cranks but Does Not Start condition on your GM 4.3L, 5.0L, 5.7L pick up, van or SUV is not that hard to do, if you have a solid diagnostic strategy. In this article I’ll show you the basics of testing such a problem.

Can a bad ignition module cause no spark?

CASE 2: You got NO spark. Then further testing is required to see if the problem is due to a bad ignition control module (ICM), or a bad pick up coil or something else. In the next round of tests we’ll get closer to the component that has failed (and the truth shall set you free).

What causes a GM pick up to not start?

The one symptom that’s gonna’ be staring you right in the face is your GM pick up or van or SUV cranking but not starting. More specifically, you’ll see one or all of the following symptoms when the crank sensor fails: No spark from all of the Coil-On-Plug Ignition Coils.

How to start a car with no spark?

Activate the 8 COP coils to spark. Activate all 8 fuel injectors to start spraying fuel into the cylinders. Maintain the fuel pump activated after its initial start. With fuel and spark now present, the engine now starts.

Can a failed crank sensor cause no start?

The thing to remember about having a failed crank sensor, is that if you have spark or fuel injector pulses, the crank sensor is OK and not the cause of your No Start Condition. The crankshaft position sensor, on your 4.8L, 5.3L, 6.0L GM vehicle, is a Hall-Effect three wire crankshaft position sensor.

Author Image
Ruth Doyle