Other

Is the 2006 International 4300 truck for sale?

Is the 2006 International 4300 truck for sale?

2006 International 4300, 21663, Michigan’s Largest Family Owner Rental Company has this 2006 Pre Emission Reefer St Truck For Sale.. Maintained to DOT…

Why is my international 4300 DT 466 AC not working?

Im working on another ac, 2005 international 4300 dt 466 we replaced 3 major ac hoses, orfice tube, high pressure sensor and recharged the system as international specs. Well we started the system and is not blowing cold air, is 85f inside cab. Did we missed anything

How much Freon does an international 4300 hold?

PUT TWO NEW THERMISTERS IN IT,part #3622764c3 and if its a two door cab it should hold 2 lbs of freon and if its a extra cab it should hold 2.25 lbs.hope this helps.

What should the high pressure switch be on an international 4300?

Sounds like the high pressure switch is bad. The high side should go up close to 300psi before it cuts the compressor off. The normal opperating range for the high side is 180-250 and your not getting that.

What kind of truck is the 2006 International 4300?

#1502 is a 2006 International 4300 Utility Truck. Truck is equipped with the DT466 diesel engine with 153,537 miles and a 6-spd transmission. Telelect… 2006 INTERNATIONAL, 4300, Medium Duty Trucks – Flatbed Trucks, International DT-466, Automatic, good truck, runs great, hydraulic brakes, NON CDL, air…

How does the body controller work on an international 4300?

Can we start with the last 8 digits of the vin number please And the way it works is one side is called the draw tank The body controller reads the fuel level sensor data from both tanks as the engine uses up the fuel in the draw tank , the level goes down

Im working on another ac, 2005 international 4300 dt 466 we replaced 3 major ac hoses, orfice tube, high pressure sensor and recharged the system as international specs. Well we started the system and is not blowing cold air, is 85f inside cab. Did we missed anything

How to check a 2005 International 4300 for faults?

To display diagnostic codes, set the parking brake and turn the Ignition key “ON”. Then press the Cruise “ON” switch and the Cruise “Resume” switch simultaneously for at least 3 seconds. If no faults are present, the

Author Image
Ruth Doyle