How wide is a Ford Crown Vic rear end?

Width between the wheel mounting surfaces on the Explorer is 59.5″; google says the police/Crown Vic 8.8″ is closer to 65″ between wheel mounting surfaces.

What is the width of a Crown Vic front end?

The Crown Vic front features heavy duty components, low cost and wide availability. The only downside of the Crown Vic front suspension is the track width… It is about 67″ wide as measured from hub / hub. While this is great for Taxis and Cop Cars, this is just to wide for older vehicles.

Will Crown Vic rear end fit Mustang?

since the crown vic has a completely different chassis, you would have to do alot of fabrication to make it fit. with the time and money you spend on the crownvic rear end you could have just payed for an 8.8 out of a mustang.

How big is the rear axle on a Crown Victoria?

Code Application Ring Gear And Pinion Ring Gear And Pinion NL or L Ratio Diameter of RG V012-A Ford Pass., Mercury 86-91 2.73 8.8 NL V012-B Ford Pass., Mercury 88-91 2.73 8.8 NL V012-D Crown Victoria, Grand Marquis 90-91 2.73 8.8 NL

How to find out what rearend do I have?

If you really want to find out what rearend you have remove the differential cover…the ratio will be stamped somewhere on the ring gear.

What are the dimensions of a rear end?

The following is a general list of rear ends and their dimensions to help narrow the search for a possible candidate to replace the torque tube rear end or just get a better set of gears for highway driving. Advance Design Trucks seem to be using rear ends with widths ranging from 58″- 62″. I’m not sure of the Task Force width ranges at this time.

How to rebuild 8.8 and 9 inch differentials?

This Tech Tip is From the Full Book, FORD DIFFERENTIALS: HOW TO REBUILD THE 8.8 AND 9 INCH. For a comprehensive guide on this entire subject you can visit this link:

How big is the pinion on a 9 inch differential?

The 9-inch’s very large pinion offset of 2.25 inches requires the pinion to be straddle mounted, which refers to the fact the pinion head has bearings that straddle it on either side. There is a machined roller bearing race on the pinion head portion that points at the differential opposite the tapered bearing races.

How wide is a Ford Crown Vic rear end?