How to replace the thermostat housing on a house?
How to replace the thermostat housing on a house?
Unbolt the cable from the alternator and disconnect the other two electrical connectors. Lay it aside so that it makes as much room as possible over the thermostat housing. Using your 8 mm swivel socket and an extension, unbolt the three bolts holding the thermostat cover on. Remove the cover. Under the cover you’ll find the thermostat.
How do you replace an upper thermostat on a radiator?
First, use the channel lock pliers to loosen the squeeze clamp on the upper radiator hose (this is the big hose that wraps around the oil fill port and connects the radiator to the upper thermostat housing). Squeeze the clamp, pull it back, pull the hose off the housing, and lay it aside.
When did Ford Ranger thermostat housing come out?
It was manufactured starting in 2001 (before that was an OHV version). An increasingly common complaint is a failure of the lower thermostat housing. On my 2003 Ford Ranger with 160k miles, this housing sprung a leak along the seam between its upper and lower portions.
How can I remove the thermostat from my car?
Squeeze the clamp and move it down just enough to clear the nipple. When you pull the housing up and out in a minute, it will then be able to pull out of this hose. Now you can finally remove the three bolts holding the lower housing to the engine. The front two are easy.
Unbolt the cable from the alternator and disconnect the other two electrical connectors. Lay it aside so that it makes as much room as possible over the thermostat housing. Using your 8 mm swivel socket and an extension, unbolt the three bolts holding the thermostat cover on. Remove the cover. Under the cover you’ll find the thermostat.
It was manufactured starting in 2001 (before that was an OHV version). An increasingly common complaint is a failure of the lower thermostat housing. On my 2003 Ford Ranger with 160k miles, this housing sprung a leak along the seam between its upper and lower portions.
First, use the channel lock pliers to loosen the squeeze clamp on the upper radiator hose (this is the big hose that wraps around the oil fill port and connects the radiator to the upper thermostat housing). Squeeze the clamp, pull it back, pull the hose off the housing, and lay it aside.
How much oil does a 4.0L SOHC V6 take?
The crankcase oil capacity on the 4.0L SOHC V6 is 5 quarts, usually 5W-30 for the older vehicles and 5W-20 for the newer ones. Refer to the vehicle owner’s manual for the recommended viscosity.
