How to recover GM air bag crash data?

Most GM dealers are not aware that the air bag SDM module records crash data. The only way to recover General Motors crash data is to use the Bosch / Vetronix CDR equipment. A dealership GM Tech 2 / MDI scan tool cannot recover the recorded vehicle crash data.

What should I do if my airbag light does not come on?

Turn your 1998 VW on and allow the airbag light to come on. Wait for at least six seconds to make sure the light stays on or continues to flash. This indicates the airbag will not deploy, even if you are in an accident. Turn your engine off. Purchase an SRS scanning tool. You can find these through several online companies.

What do I need to install an airbag on off switch?

If you would like to get an on-off switch installed in your car, you need a copy of NHTSA’s brochure, “airbags and On-Off Switches: Information for an Informed Decision,” and the accompanying form, Request for airbag On-Off Switch.

Is there a way to deactivate an airbag?

How Airbags Work. Generally speaking, you can’t deactivate your airbag without installing a retrofit on-off switch. However, if a retrofit on-off switch is not yet available (from the vehicle manufacturer) for your car, the NHTSA will authorize airbag deactivation on a case-by-case basis under appropriate conditions.

How to turn off right front airbag in GMC Sierra?

In a crash, the airbag will not be able to inflate and help protect the person sitting there. Do not turn off the passenger airbag unless the person sitting there is in a risk group. To turn off the right front passenger airbag, insert the ignition key into the switch, push in, and move the switch to the off position.

How to turn off the right front airbag?

Do not turn off the passenger airbag unless the person sitting there is in a risk group. To turn off the right front passenger airbag, insert the ignition key into the switch, push in, and move the switch to the off position.

Is there an air bag warning light on my GMC Sierra 1500?

Tl the contact owns a 2005 GMC Sierra 1500. The contact stated that the air bag warning indicator illuminated. The vehicle was taken to an independent mechanic who referred the contact to NHTSA. The vehicle was not diagnosed or repaired. The dealer and manufacturer were not contacted.

Why is my air bag light not turning on?

Also please check out the statistics and reliability analysis of GMC Sierra 1500 based on all problems reported for the Sierra 1500. Left side impact sensor loses connectivity from wires shorting out in drivers hinge area. Service air bag light comes on. See all problems of the 2012 GMC Sierra 1500 . Service airbag light will not turn off.

How do you install an airbag control module?

All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.

What to do if your front airbag resistance is too high?

Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors. Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.

Where is the SRS airbag control module located?

In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.