How to install solenoid valve in Ford 6F35?

How to install solenoid valve in Ford 6F35?

Valve Body 6b Plastic Checkballs 6a Solenoid Valve Body NOTE: The components in this kit are all related to the valve body. It is not necessary to remove pump for kit installation; pump should only be removed if vacuum testing pump locations is desired. Drill solenoid pressure regulator balance hole and seal with .062″

Why do you need a full manual valve body?

TCI® Full Manual Valve Bodies allow for quicker shift timing and the ability to run higher line pressures than with an automatic shift. Designed for maximum performance & quick ETs Quicker shift timing is perfect for race applications Higher line pressure makes it more difficult for clutches to slip under high loads

How do you install a sleeve on a Ford 6F35?

Secure sleeve in bore by installing included clip into sleeve groove at inboard port. Install included spring and secure all in bore with OE retainer. Packaging Pocket 5 • Sleeve • Valve • Spring • Retainer Clip Step Replace OE Accumulator Piston Remove and discard OE rubber-tipped damper piston from valve body

How do you replace an OE forward modulator valve?

Replace OE Forward Modulator Valve By positioning the manual valve furthest into the bore, air pressure can be used to blow the modulator valve out. If there is any visible wear or ridge in the bore, buff this area with Scotch-Brite™ placed on a twisted wire and inserted into drill. Install the PTFE seal onto the Sonnax valve.

How to install a full manual valve body?

Install gasket, separator plate, gasket, and BTE manual valve body. Bolt valve body to transmission, after hand starting all bolts. Tighten the 5/16″ bolts to 15 foot-pounds of torque and the 1/4″ bolts to 8 foot-pounds.

How do you line up a manual valve?

You must line up the manual valve with the detent lever of your transmission. The OEM manual valve is used with this valve body kit. The manual valve has an opening that the detent will fit into. The detent lever moves the manual valve when you manually shift the vehicle. You are now ready to install the manual valve body.

How to install a BTE manual valve body?

STEP 14: Next install your BTE manual valve body. You must line up the manual valve with the detent lever of your transmission. The OEM manual valve is used with this valve body kit. The manual valve has an opening that the detent will fit into. The detent lever moves the manual valve when you manually shift the vehicle.