How to fix Ford Edge compass module error?
How to fix Ford Edge compass module error?
Compass Module Error. Compass Data Error. These errors flash on the odometer along with a very annoying beep. This happens numerous times in succession, then does not do it for 10 minutes. Have attempted to re-calibrate the compass several times and it is good for about 30 miles of travel, then without warning, it occurs again.
Are there any problems with the Ford Edge?
THESE ERRORS FLASH ON THE ODOMETER ALONG WITH A VERY ANNOYING BEEP. THIS HA Having problems with your Ford Edge ? Compass Module Error.
How to calibrate the compass on a Ford Escape?
1. Start the vehicle. 2. To calibrate, press and hold the RESET control for approximately ten seconds until CAL appears. Release the control. 3. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CAL display changes to the direction value. It may take up to five circles to complete calibration. 4.
How to change the direction of the compass?
Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display. 5. Continue to press the RESET control until the correct zone appears in the center stack display. 6. The direction will display after the RESET control is released. The zone is now updated.
Compass Module Error. Compass Data Error. These errors flash on the odometer along with a very annoying beep. This happens numerous times in succession, then does not do it for 10 minutes. Have attempted to re-calibrate the compass several times and it is good for about 30 miles of travel, then without warning, it occurs again.
THESE ERRORS FLASH ON THE ODOMETER ALONG WITH A VERY ANNOYING BEEP. THIS HA Having problems with your Ford Edge ? Compass Module Error.
1. Start the vehicle. 2. To calibrate, press and hold the RESET control for approximately ten seconds until CAL appears. Release the control. 3. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CAL display changes to the direction value. It may take up to five circles to complete calibration. 4.
Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display. 5. Continue to press the RESET control until the correct zone appears in the center stack display. 6. The direction will display after the RESET control is released. The zone is now updated.
